User Manual

ManualsBrandsKustom Musical Amplification ManualsElectronicsPower Amplifier

PW150TFX &

PW150TFXBT

Owner’s Manual

Congratulations on

the purchase of your

Powerwerks PA.

Your PW Model draws on decades

of amp design and manufacturing

experience at Powerwerks. This model

was built from the ground up to offer

world-class tone, useful features and

reliable performance. Inside this manual,

you’ll nd valuable information about your

product’s controls and specications.

Being familiar with its features will help

you effectively use your system. We wish

you many years of enjoyment with your

Powerwerks PA

Summary of content (12 pages)

PAGE 1
PW150TFX & PW150TFXBT Owner’s Manual Congratulations on the purchase of your Powerwerks PA. Your PW Model draws on decades of amp design and manufacturing experience at Powerwerks. This model was built from the ground up to offer world-class tone, useful features and reliable performance. Inside this manual, you’ll find valuable information about your product’s controls and specifications. Being familiar with its features will help you effectively use your system.
PAGE 2
PAGE 3
IMPORTANT SAFETY INSTRUCTIONS Danger Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably to noise induced hearing loss but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. The U.S.
PAGE 4
IMPORTANT SAFETY INSTRUCTIONS FRENCH 1. Danger L‘exposition a des niveaux eleves de bruit peut provoquer une perte permanente de l’audition, Chaque organisme humain reagit differemment quant a la perte de l’audition, mais quasiment tout le monde subit une diminution de I’acuite auditive lors d’une exposition suffisamment longue au bruit intense.
PAGE 5
SPEAKER STAND SAFETY Speakers on stands can fall over and cause injury if set up improperly. Make sure the legs of the tripod are at least 44 inches (111.9 cm) apart, with an angle to the floor of 30 degrees. The ideal height for the unit is 6 feet 6 inches. Make sure the speaker stand mount is properly seated on the speaker stand pole. 6’6” (198 cm) 30 44” (111.
PAGE 6
6 5 5 4 4 2 3 7 8 1 11 9 10 12 13 14 BLUETOOTH PAIRING INSTRUCTIONS: To connect your Bluetooth device to the Powerwerks Bluetooth receiver for the first time, navigate to the Bluetooth settings menu on you Bluetooth enabled device. Ensure that Bluetooth is enabled and your Powerwerks product is powered on. Perform a scan for available devices. Select and pair to the Powerwerks product in the list of available devices. Enter 0000 for the passcode if prompted.
PAGE 7
CONTROLS & FUNCTIONS OVERVIEW INPUT SECTION: This is where you may plug in microphones, instruments, keyboards, drum machines and other audio devices, adjust the volume, bass and treble. 1. MIC Inputs: These XLR inputs are designed for low-impedance microphones or equipment that has a mic-level, balanced output (often called a Direct Out). Note: These inputs receive 15-volt phantom power. This is used to provide power to condenser microphones.
PAGE 8
PW150TFX/PW150TFXBT Specifications Output Power 1% 2 x 75W CH1 and CH2 Ch3 20HZ-20kHZ 2 x 4 ohm load Mic XLR Balanced, Line Level 1/4" Un-balanced Accepted Inputs 1/8" Line Level or Bluetooth Device (150TFXBT models) Actual response is tailored to speaker cabinet for accurate Frequency Response acoustical response -46dB Residual Noise, all level controls 0% (mimimum) Hum & Noise -37dB Nominal System Noise, all level controls at 50% Mic to Speaker Output (CH 1 & CH2) System Gain/Speaker Output +49dB (Measu
PAGE 9
3 2 1 AUX MIC LINE MIC LINE PW150TFXBT Only Bluetooth Receiver Phantom Power 15V Phantom Power 15V GAIN Effect Select GAIN high Aux Input Disables Bluetooth high volume Effect Level 2 volume low low volume Effect Level 1 high Digital Effects low CHANNELS BALANCED MONITOR OUT OUT IN SYNC LINKING BUS MONITOR LEVEL MASTER MASTER SUB LP Filter Conditioning Hi Pass Filter (HPF) POWER AMP1 Crossover + _ + _ _ + _ + + _ SUBWOOFER OUT Inserting 1/4" mono (tip/sleeve
PAGE 10
This warranty is for Powerwerks products only. Any service claims resulting from other brands used in conjunction with Powerwerks products will not be allowed or honored. This warranty will be void if: A. The unit has been altered or modified. B. The serial number has been removed or defaced. C. The unit has been operated improperly. This warranty is subject to the following conditions and exclusions: Defects caused by wear and tear, misuse or neglect are not covered by this warranty.
PAGE 11
EC Declaration of Conformity We: Kustom Musical Amplification INC. 3015 Kustom Drive Hebron, Ky 41048 Tel: 1-859-817-7164 Fax: 1-859-817-7199 Declare that the product Product name: Powerwerks Product model number: PW150TFX & PW150TFXBT to which this declaration relates is in conformity with the following standards; EN55013: 2001/+A1: 2003+A2: 2006 Limits and methods of measurement of radio disturbance characteristics of broadcast receivers and associated equipment.
PAGE 12
PW150TFX / PW150TFXBT OWNER’S MANUAL www.powerwerks.