BATTERY POWERED PA PW40BAT / PW40BATBT Congratulations on the purchase of your Powerwerks Battery Powered PA. Powerwerks PW40BAT and PW40BATBT Models draw on decades of amp design and manufacturing experience at Powerwerks. These products were built from the ground up to offer world-class tone, useful features and reliable performance. Inside this manual, you’ll find valuable information about your product’s controls and specifications.
IMPORTANT SAFETY INSTRUCTIONS Danger Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably to noise induced hearing loss but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. The U.S.
IMPORTANT SAFETY INSTRUCTIONS FRENCH 1. Danger L‘exposition a des niveaux eleves de bruit peut provoquer une perte permanente de l’audition, Chaque organisme humain reagit differemment quant a la perte de l’audition, mais quasiment tout le monde subit une diminution de I’acuite auditive lors d’une exposition suffisamment longue au bruit intense.
CONTROLS & FUNCTIONS OVERVIEW 1 2 3 4 5 6 7 1. AUX IN: Use this stereo input to connect an external audio device such as an MP3, CD player or computer for playback. Note: Right and Left channels are summed to mono on this input. 2. MIC Input: This XLR input is designed for low-impedance microphones or equipment that has a mic-level, balanced output. Note: This input sends 9-volt phantom power. This is used to provide power to condenser microphones.
1 2 3 4 6 5 7 PW40BATBT: BLUETOOTH PAIRING INSTRUCTIONS To connect your Bluetooth device to the Powerwerks Bluetooth receiver for the first time, navigate to the Bluetooth settings menu on you Bluetooth enabled device. Ensure that Bluetooth is enabled and your Powerwerks product is powered on. Perform a scan for available devices. Select and pair to the Powerwerks product in the list of available devices. Enter 0000 for the passcode if prompted. Once paired, a connection can be established.
BATTERY: IT IS RECOMMENDED THAT THE BATTERY BE RECHARGED AFTER USE TO PROLONG THE BATTERY LIFE. FREQUENT CHARGING WILL NOT HARM YOUR BATTERY, AND WILL ENSURE THAT THE BATTERY IS FULLY CHARGED AND READY FOR ITS NEXT USE. STORING BATTERY NOT FULLY CHARGED WILL SHORTEN BATTERY LIFE. -Always charge for 12 full hours after heavy use. -The battery does not need to be fully discharged before recharging. -It is recommended to stop using the unit under battery power when red Battery Level LED is on.
BATTERY REPLACEMENT The battery will need to be replaced when the unit fails to charge. Carefully follow the installation instructions for battery replacement. Perform battery replacement in a safe place, away from children. Remove the four screws in the lower portion of the rear of the cabinet & remove the battery panel. Holding the cabinet securely, carefully tilt the it backwards. The battery should slide out of it’s compartment. Disconnect the two wires attached to the battery.
MIC XLR LINE 1/4" 2 LINE 1/4" S T CS CN Bluetooth Pwr R Phantom Power 9V Feature on PW40BATBT only BLUETOOTH AUX 1/8" 1 GAIN GAIN volume volume CHANNELS low low high high OUT IN POWERLINK MASTER LINKING BUS MASTER Conditioning HORN Crossover + _ + _ + _ SPEAKER POWER AMPs SPEAKERS PW40BAT & PW40BATBT SIGNAL FLOW DIAGRAM MAIN BUS
This warranty is for Powerwerks products only. Any service claims resulting from other brands used in conjunction with Powerwerks products will not be allowed or honored. This warranty will be void if: A. The unit has been altered or modified. B. The serial number has been removed or defaced. C. The unit has been operated improperly. This warranty is subject to the following conditions and exclusions: Defects caused by wear and tear, misuse or neglect are not covered by this warranty.
PW40BAT / PW40BATBT OWNER’S MANUAL www.powerwerks.