User Manual

PAGE 1
309234
DPF-MRK-003 REV A 11/21/16
FINNED PRIMARY INSPECTION COVER ACCENT FOR SOFTAIL AND DYNA, CHROME
9234
866 277 9598 | [e-mail]
454 COUNTY ROAD VV SOMERSET, WI 54025
KURYAKYN.COM
INSTALLATION INSTRUCTIONS
THANK YOU FOR CHOOSING KURYAKYN!
Protect yourself and others from possible injury and property damage or loss. Pay close attention to all instructions, warnings, cautions, and notices regarding the installation, use, and care of this product.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN RESULT IN POTENTIAL DEATH OR SERIOUS INJURY.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN RESULT IN MINOR OR MODERATE POTENTIAL INJURY.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN MAY NEGATIVELY AFFECT PRODUCT PERFORMANCE AND FUNCTIONALITY OR
DAMAGE THE PRODUCT ITSELF OR THE PRODUCT TO WHICH IT IS BEING ATTACHED.
ENSURE THAT THE FOLLOWING PARTS HAVE BEEN INCLUDED IN THE KIT:
1 Primary Inspection Cover Accent 1 Alcohol Pad
YOU WILL ALSO NEED:
Clean rag and warm soapy water
THESE INSTALLATION INSTRUCTIONS CONTAIN IMPORTANT INFORMATION. ENSURE THE END USER RECEIVES THIS COPY AND IS AWARE
OF ITS IMPORTANCE FOR FUTURE USE.
STEP 1
Read and understand all steps in the instructions before starting the
installation. Park the motorcycle on a hard, level surface and turn off
the ignition. Let motorcycle cool.
ENSURE PROPER ADHESION OF THIS PRODUCT. REMOVE ALL GREASE,
OIL, BUGS, DIRT, AND OTHER DEBRIS (INCLUDING WAX AND POLISH)
FROM THE INSTALLATION AREA. KURYAKYN WILL NOT PROVIDE
WARRANTY COVERAGE ON PRODUCTS OR COMPONENTS LOST OR
DAMAGED DUE TO IMPROPER INSTALLATION.
DO NOT ATTEMPT THIS INSTALLATION IN TEMPERATURES BELOW 50°F
(10°C). PROPER ADHESIVE BONDING ONLY OCCURS ABOVE 50°F
(10°C).
STEP 2
Refer to PIC 2. Using warm soapy water and a clean rag, remove all dirt
and debris from the installation area; allow the area to dry completely.
Wipe the installation area with the included alcohol pad to remove any
wax or polish; allow the area to dry completely.
STEP 3
Test fit the Cover. Use your fingernail to rub the adhesive backing; this
will activate the adhesive. Remove and discard the backing.
STEP 4
Refer to PIC 2 and 3. Align the Cover; press into place for one minute;
full bonding will occur after 24 hours.
Note: If the bike is going to be operated before full bonding occurs,
secure the cover to the bike with a good quality masking or painter’s
tape.
PIC 1
PIC 2
PIC 3
PICTURES SHOWN ARE OF THE BLACK ACCENT. INSTALLATION OF THE CHROME ACCENT WILL BE THE SAME.