User Manual

ManualsBrandsKuryakyn ManualsAccessoriesMotorcycle Accent Accessory: Tri-Line Stereo Trim for 2015-19 Harley-Davidson Road Glide Motorcycles with Boom! Box 4.3 Stereo, Chrome

TRI-LINE STEREO TRIM FOR ROAD GLIDE WITH BOOM! BOX 4.3, CHROME

6966

Page 1

This indication alerts you to the fact that ignoring the contents described herein may negatively affect product per-

formance and functionality or damage the product itself or the product to which it is being attached.

ENSURE THAT THE FOLLOWING PARTS HAVE BEEN INCLUDED IN THE KIT:

1 Stereo Accent

1 Stereo Bezel

1 Alcohol Pad

1 Installation Instructions

YOU WILL ALSO NEED:

Warm, soapy water and clean rag, masking or painter’s tape, marker

Ensure proper adhesion of this product. Remove all grease, oil,

bugs, dirt, and other debris (including wax and polish) from the

installation area. Kuryakyn will not provide warranty coverage on

products or components lost or damaged due to improper instal-

lation.

Do not attempt this installation in temperatures below 50°F (10°

C). Proper adhesive bonding ONLY occurs above 50°F (10°C).

Thank You For Choosing Küryakyn!

Protect yourself and others from potential injury and property damage or loss. Pay close attention to all instructions, warnings, cautions, and notices

regarding the installation, use, and care of this product.

STEP 1 Read and understand all steps in the instructions before starting the installation. Park

the motorcycle on a hard, level surface and turn IGN OFF.

STEP 2 Refer to PIC 1. Using warm soapy water and a clean rag, remove all dirt and debris

from the installation area; allow the area to dry completely.

Wipe the installation area with the included alcohol pad to remove any wax or polish;

allow the area to dry completely.

STEP 3 Test fit the Accent and Bezel as shown in PIC 2 and 3. Use masking tape to make align-

ment marks; remove the Accent and Bezel.

STEP 4 Use your fingernail to rub the adhesive backing; this will activate the adhesive. Remove

and discard the backing.

STEP 5 Refer to PIC 2. Align the Bezel; press into place for one minute; full bonding will occur

after 24 hours. Remove and discard the masking tape.

STEP 6 Repeat for the other Accent..

NOTE: If the bike is going to be operated before full bonding occurs, secure the

Accent to the fairing with a good quality masking or painter’s tape.

CLEAN + DRY

PIC 1

PIC 2

PRESS INTO PLACE

FOR 60 SECONDS

PIC 3

PRESS INTO PLACE

FOR 60 SECONDS

6966-11HD-0815