Installation Manual

ManualsBrandsKuryakyn ManualsAccessoriesKuryakyn 2715 MTX Road Thunder Weather Resistant Motorcycle Sound Bar: 150 Watt Handlebar Mounted Audio Speakers with Bluetooth, Satin Black

PAGE 1

302715

DPF-MRK-003 REV A 7/20/16

ROADTHUNDER SOUND BAR BY MTX, SATIN BLACK 2715

866 277 9598 | INFO@KURYAKYN.COM

454 COUNTY ROAD VV SOMERSET, WI 54025

KURYAKYN.COM

INSTALLATION INSTRUCTIONS

THANK YOU FOR CHOOSING KURYAKYN!

Protect yourself and others from possible injury and property damage or loss. Pay close attention to all instructions, warnings, cautions, and notices regarding the installation, use, and care of this product.

THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN RESULT IN POTENTIAL DEATH OR SERIOUS INJURY.

THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN RESULT IN MINOR OR MODERATE POTENTIAL INJURY.

THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN MAY NEGATIVELY AFFECT PRODUCT PERFORMANCE AND FUNCTIONALITY OR

DAMAGE THE PRODUCT ITSELF OR THE PRODUCT TO WHICH IT IS BEING ATTACHED.

ENSURE THAT THE FOLLOWING PARTS HAVE BEEN INCLUDED IN THE KIT:

1 RoadThunder® Sound Bar

1 Hardware Kit containing:

2 Sound Bar Mounting Clamps 2 M6-1.0 X 35MM Button Head

Hex Screws

2 7/8” Clamps 2 M6-1.0 Lock Nut w/Washers

2 1” Clamps 2 M6-1.0 X 14MM Cap Screws

2 1-1/8” Clamps 2 M6 Split Washers

2 1-1/4” Clamps 2 M4-0.7 X 10MM Set Screws

1 Transparent Film 1 2MM Allen Wrench

1 10 Amp Mini Fuse

1 T-Tap Quick Connect Female

4 Cable Ties

YOU WILL ALSO NEED:

Metric Hex, Allen wrenches, pliers

THESE INSTALLATION INSTRUCTIONS CONTAIN IMPORTANT INFORMATION. ENSURE THE END USER RECEIVES THIS COPY AND IS AWARE

OF ITS IMPORTANCE FOR FUTURE USE.

WHEN CONNECTING POWER AND GROUND WIRES ENSURE THAT THE RED POWER WIRE IS FUSED AT THE POINT WHERE IT IS

CONNECTED TO THE VEHICLE’S BATTERY. FAILURE TO DO SO CAN RESULT IN DAMAGE TO THE VEHICLE IF A SHORT CIRCUIT DEVELOPS

BETWEEN THE VEHICLE CONNECTION POINT AND THE PRODUCT.

Summary of content (5 pages)

PAGE 1
INSTALLATION INSTRUCTIONS ROADTHUNDER SOUND BAR BY MTX, SATIN BLACK 2715 THANK YOU FOR CHOOSING KURYAKYN! Protect yourself and others from possible injury and property damage or loss. Pay close attention to all instructions, warnings, cautions, and notices regarding the installation, use, and care of this product. THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN RESULT IN POTENTIAL DEATH OR SERIOUS INJURY.
PAGE 2
INSTALLATION INSTRUCTIONS ROADTHUNDER SOUND BAR BY MTX, SATIN BLACK 2715 -CONTINUED- INTRODUCTION Thank you for purchasing this Kuryakyn RoadThunder Sound Bar by MTX that is designed to work with most Bluetooth enabled devices including iPhone® and Android® smartphones and tablets. This easy to install and use, all in one unit is capable of transforming your Bluetooth enabled mobile device into the center of your vehicle’s audio system.
PAGE 3
INSTALLATION INSTRUCTIONS ROADTHUNDER SOUND BAR BY MTX, SATIN BLACK 2715 -CONTINUED- INSTALLATION SCENARIO 2 - INSTALL SOUND BAR, THEN MOUNTS CLAMPS TO HANDLEBAR. • Choose the correct size strap clamp for the handlebars. Note: Placing the transparent film between the strap clamp and handlebar will reduce the possibility of scratching the handlebars during installation. • Slide the sound bar into the brackets from the left side, so the brackets can clear the buttons without damaging them.
PAGE 4
INSTALLATION INSTRUCTIONS ROADTHUNDER SOUND BAR BY MTX, SATIN BLACK 2715 -CONTINUED- ELECTRICAL OPERATION Tap the Power button to turn the unit on. (Power, Ground, and Ignition wire need STEP 1 STEP 2 STEP 3 STEP 4 STEP 5 to be connected to a 12V power source.) Tap the Power button to switch modes between Bluetooth and AUX. Hold the Power button for 2 seconds to turn the unit Off. The integrated fuse and ring terminals allow for easy wire connection to a 12V power source.
PAGE 5
INSTALLATION INSTRUCTIONS ROADTHUNDER SOUND BAR BY MTX, SATIN BLACK 2715 -CONTINUED- STEP 2 STEP 3 The RoadThunder Sound Bar can be used with a second RoadThunder Sound Bar unit. For the best audio performance, the second unit connected via Auxiliary should have the volume set to the max. The blue wire on the wire harness can be used as a remote turn on for the second audio device. CONTROLLING THE VOLUME The LED indicator light will blink in both Bluetooth and AUX modes at max volume.