User Manual

PAGE 1
301693-1215
TECH-CONNECT DEVICE HOLDER 1693
866 277 9598 | INFO@KURYAKYN.COM
454 COUNTY ROAD VV SOMERSET, WI 54025
KURYAKYN.COM
INSTALLATION INSTRUCTIONS
THANK YOU FOR CHOOSING KURYAKYN!
Protect yourself and others from possible injury and property damage or loss. Pay close attention to all instructions, warnings, cautions, and notices regarding the installation, use, and care of this product.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN RESULT IN POTENTIAL DEATH OR SERIOUS INJURY.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN RESULT IN MINOR OR MODERATE POTENTIAL INJURY.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN MAY NEGATIVELY AFFECT PRODUCT PERFORMANCE AND FUNCTIONALITY OR
DAMAGE THE PRODUCT ITSELF OR THE PRODUCT TO WHICH IT IS BEING ATTACHED.
ENSURE THAT THE FOLLOWING PARTS HAVE BEEN INCLUDED IN THE KIT:
1 Tech-Connect Device Holder 1 Hardware Kit Containing:
1 Installation Instructions 2 #8-32 X 5/8" Phillips Head Pan Screws
2 #8 SAE Flat Washers
4 6" Black Nylon Cable Ties
1 Thin Foam Pad
YOU WILL ALSO NEED:
Small Phillips Screwdriver
THESE INSTALLATION INSTRUCTIONS CONTAIN IMPORTANT INFORMATION. ENSURE THE END USER RECEIVES THIS COPY AND IS AWARE
OF ITS IMPORTANCE FOR FUTURE USE.
STEP 1
Read and understand all steps in the instructions before starting the installa-
tion. Park the motorcycle on a hard, level surface and turn off the ignition.
NOTE: The Tech-Connect Mobile Device Holder requires the separate purchase
and installation of an accessory mount.
NOTE: For devices measuring 1-5/8” to 3-5/8” wide.
ENSURE THAT THE INSTALLATION OF THIS PRODUCT DOES NOT INTERFERE WITH
THE PROPER OPERATION OF THE MOTORCYCLE BEFORE RIDING.
IT IS THE INSTALLER’S RESPONSIBILITY TO ENSURE THAT THERE IS ADEQUATE
CLEARANCE BETWEEN THE TECH-CONNECT AND ANY PAINTED SURFACES.
KURYAKYN IS NOT RESPONSIBLE FOR ANY DAMAGE DUE TO INADEQUATE
CLEARANCE.
PIC.1
BE AWARE OF ANY CABLES/WIRES THAT COULD POTENTIALLY BE PINCHED OR
CRUSHED WHILE USING THIS PRODUCT.
STEP 2
The Tech-Connect Device Holder can be mounted to Kuryakyn Accessory
mounts with ease. PIC 1 It may fit other accessory mounts with two mounting
holes 1-15/16” apart for mounting with #8-32 screws. Works well with Ram
Mounts.

Summary of content (4 pages)