Manual

NOTICE: Please contact Kurgo directly with
any product or return inquiries.
[e-mail] • 877-847-3868
Washing instructions:
• Brush off loose dirt with a dry brush.
• As needed, wipe off with a damp sponge and mild soap.
Liner is machine washable, hang to dry.
For more information: 877.847.3868 :: www.kurgo.com :: [e-mail]
6-12
WARNING: After clipping the tether strap to a dog harness, adjust the length of the strap
to keep dog from jumping out. Always use a harness with the booster seat, collars are not
suitable for automotive restraint. Never leave a dog unattended in the vehicle.
Installation & Care
BASIC SETUP
1. Locate the Kurgo logo at the front of the booster seat, un-Velcro
2. Lift up the rectangular support brace (E) and clip the small surrounding
straps together to keep the brace in place. Re-attach the liner and follow
below for further vehicle installation.
INSTALLATION IN VEHICLE:
1. Buckle the seat belt where the booster seat will be installed.
Loop over the top of the headrest. Use the Strap Adjuster (B) to select
a suitable height for your Booster Seat.
2. Wrap Seat back Strap (C) around the back of the seat and clip buckles
3.
attached you are ready to roll.
INSTALLATION IN VEHICLE WITHOUT HEADREST:
1. Buckle the seat belt where the booster seat will be installed.
Loop over the top of the seat. Extend the length of the Headrest Strap
(A) so the bottom of Booster rests on seat.
2. Wrap Seat back Strap (C) around the back of the seat and clip buckles
3.
attached you are ready to roll.


A
B
D
Check with vehicle maunfacturer for air bag guidelines.
A
B
C
A
B
D
Headrest Strap Adjuster
Headrest Strap
Seat Back Strap
Harness Tether
Support Brace
KEY
C
E
E
USING THE TETHER WITH YOUR VEHICLE’S SEAT BELT
1. Remove carabiner (C) an loop tether around the seatbelt (A) and pull back through tether handle.
2. Pull strap through slide (B) located in the back of the Booster Seat.
3. Re-attach carabiner (C) to strap and attach to Harness leash hook.

  
A
B
C
C
