User Manual

USING THE TETHER WITH YOUR VEHICLE’S SEAT BELT
1. Remove carabiner (C) and loop tether around the seatbelt (A) and pull back through tether handle.
2. Pull tether through slide (B) located in the back of the Booster Seat.
3. Re-attach carabiner (C) to strap and attach to Harness leash hook.
WARNING: After clipping the tether strap to a dog harness, adjust the length of the strap
to keep dog from jumping out. Always use a harness with the booster seat, collars are not
suitable for automotive restraint. Never leave a dog unattended in the vehicle.
FIG. 3
FIG. 1
1 2 3
E
Check with vehicle manufacturer
for air bag guidelines.
A
C
A
B
D
Headrest Strap Adjuster
Headrest Strap
Seat Back Strap
Harness Tether
Strap Adjuster
KEY
E
Installation & care
INSTALLATION IN VEHICLE:
1. Buckle the seat belt where the booster seat will be
installed. Clip Headrest Strap (A) to Headrest Strap
Clips (B) on sides of Skybox frame and loop over
the top of the headrest. Use the Strap Adjuster
(E) to select a suitable height for your Skybox..
2. Wrap Seat back Strap (C) around the back of the
seat and clip buckles together. Pull strap tight (fig 2)
3. Follow the instructions below (fig 3) to secure
Tether (D). Once Fido is attached you’re ready to go.
D
C
C
FIG. 2
A
B

Summary of content (2 pages)