Owner's Manual

A Back Strap

B Leash Hitch

Nesting Buckles™

D Lower Chest Straps

E Padded Chest Plate

F Upper Neck Straps

Chest Plate D-ring

(for leash only)

Fastening the Nesting Buckles:

1. Take a piece of the Nesting Buckle in each hand.

2. Pass the smaller piece through the wide slot of the larger piece.

Kurgo logo should be pointing

3. Pull flat and snug the lower straps for a secure fit.

EN - INSTRUCTIONS AND CARE

21 3

On front,

not shown

in diagram

Fitting the harness on your dog:

1. Place upper neck straps (F) around pet’s head

2. Wrap two lower straps (D) around pet’s chest, behind front legs

3. Fasten Nesting Buckles (C) on both sides

4. Adjust all straps to fit comfortably

Seatbelt tether and carabiner

PAGE 1
EN - I N S T RU C T IO N S A N D CA RE A F Seatbelt tether and carabiner C A Back Strap B Leash Hitch B C Nesting Buckles™ D Lower Chest Straps E Padded Chest Plate G On front, not shown in diagram D E F Upper Neck Straps G Chest Plate D-ring (for leash only) Fitting the harness on your dog: 1. Place upper neck straps (F) around pet’s head 2. Wrap two lower straps (D) around pet’s chest, behind front legs 3. Fasten Nesting Buckles (C) on both sides 4.
PAGE 2
To use as a vehicle seatbelt harness: Warning! Do not use chest plate D-ring (G) or leash hitch (B) for securing in a vehicle. Replace harness if it shows signs of wear or has been in a crash situation. Attach the tether's carabiner through the top layer of the harness's back strap (A). Next, attach carabiner to buckled vehicle seatbelt, leaving tether loose.