3.1 HDO 2.
HDO 2.
HDO 2.
JXXX Hot Pocket(Small) | Illustration - Exploded View PA66 Screw to Torx 20x Cable Cover Copper Bars Ejector Pin West Toggle CAM Compression Spring Misumi:UR8-20 Push Button South Toggle CAM Washer & Collar Modules 8x Bottom Left Plate Hot Pocket Supporting Bar 3x Heater Bar Cover Heater Cartridges 4x Middle Plate Toggle Latch Compression Spring Misumi: UF6-30 Stopper Pin Bottom Right Plate RFID 4
9 Main Fixture | North Bar Module Compression Heat Cartridge Spring Microswitch Microswitch Mounting Plate Screw M2*6 Aviation Female Connector Copper Cover Plate North Heater Bar Adaptor Plate Connecting Plate Material: Glastherm HT 500 Bushing Captive Screw C-SCB3-16 Guide Pin Guide Pin Bushing Screw M3 Shoulder Screw Fixing Plate 5
7 Main Fixture | Hot Pocket - Contact Pin Module Copper Block Switching Probe Pin Housing Protective Cover/Block Aviation Connector Contact Pins Set Screw M2 Floating Block Spring Pins Copper Block Housing 6
HDO 2.0 | Main Box Front View Rubber Feet 4.
HDO 2.0 | Main Box Exploded View Type-B USB Port Main Power Inlet Sckt./Switch (100VAC ~240VAC) SD Card Supporting Bar*2 Supporting Bar*2 RFID Antenna Programmable Logic Control Board Power Supply 48V DC@550W Supporting Bar*2 Mechanical Relay Front Control Panel 4.
Thanks For Your Attention! .
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.