User Manual

SC7B-1 Case Assembly Instructions

This case is acrylic material. Please tear off the protective paper on both

sides of each piece of acrylic case before assembling. And be careful that

do not collision and fall it.

The package list:

Assembly steps:

Step 1: Find the two pieces of acrylic in the picture 1, then put them

together completely as the picture 2.

Picture 1:

PAGE 1
SC7B-1 Case Assembly Instructions This case is acrylic material. Please tear off the protective paper on both sides of each piece of acrylic case before assembling. And be careful that do not collision and fall it. The package list: Assembly steps: Step 1: Find the two pieces of acrylic in the picture 1, then put them together completely as the picture 2.
PAGE 2
Picture 2: Step 2: Place the screen on the two pieces case as the picture 3, notice that the position of the cable on the front of the screen is placed in the groove of the inner ring of the acrylic.
PAGE 3
Step 3: Find the acrylics in the picture 4, and then recombined according to the position of the corresponding hole as the picture 5.
PAGE 4
Picture 5: Step 4: Mount the bracket on the picture 5 case, and fix it with 4 M3 screws and M3 nuts as the picture 6: Picture 6:
PAGE 5
Step 5: Use 4 M2.5 screws to pass through the case, then put 4 transparent RPI washer as the picture 7 on the 4 screws, which will make the RPI fix stably. And then place the raspberry pie on the 4 corresponding screws and fix them with nuts as the picture 8 & picture 9.
PAGE 6
Picture 9: Step 6 ：Finally, combine picture 3 case and picture 9 case, fixed them together with the last 4 screws and nuts, as the picture 10.
PAGE 7
PAGE 8