Checksumme Bedienungstechnisch GEMEINSAME VERBINDUNG 1. Bitte den Draht von Hand straffen, um seine herausragend Stellen zu gléitton und Kurzschluss zu vermeiden. 2, Anschlusskimme gegen den Uhrzeigersinn drehen und Kupferkabel In das Loch einstecken. Anschlusskimme im Uhrzeigersinn anziehen, leicht am Kabel ziehen um sicherzustellen dass die Verbindung fest Ist. 3. Anschlussklemme Im Uhrzeigersinn anziehen, leicht am Kabel ziehen um sicherzustellen dass die Verbindung fest Ist.
English Owner's manual SPEAKER INSTALLATION Except the speaker units’ quality, the acoustic quality of the speaker system also depends on factors like the size and mode of rooms, speaker Installation means and so on. Thus, please pay attention to the following points during Installation: = When the speaker is placed directly on the floor, the sub woofer effect will be too much obvious. Then ane cement board or other hard support plate should be needed to be placed on the floor.
Owner's manual COMMON CONNECTION MEAN . Please tightening the wire by hand in order to settle its protruded places and avoid short circuit. 2. Reseals the copper post in counter clockwise direction, and put the copper wire info the hole. Connection to corresponding pole of the amplifier 3. Tightening the copper post in clockwise direction, gently pull the wire, and make sure connection firmly.
| English Owner's manual TECHNICAL PARAMETERS FRONT SPEAKER Speaker size: 1" Tweeter x 1 4" Mid range x 2 8" Woofer x 1 Crossover: 3 way Frequency response: kHz Sensitivity: 89 +/-3 dB Impedance: 4 Ohm Max. power: 100 Watt REAR SPEAKER Speaker Unit: 1” Tweeter x 1 3" Woofer x 1 Frequency response: 150 Hz 20 kHz Sensitivity: 86 +/-3 dB Impedance: 4 Ohm Max.