Owner’s Manual Seismix Cube
Congratulations on choosing Krix The Seismix Cube active subwoofers will complement existing Stereo or Home Theatre systems producing an increase in low frequency performance for a deep experience. The Seismix Cube is compatible with a variety of small to large sized, sealed or vented, main/satellite speakers. Your subwoofer is powered by an efficient class-D amplifier capable of delivering maximum output with low distortion for sustained periods of listening enjoyment.
controls and features volume Adjusts the subwoofer’s output level. phase Allows the phase of the subwoofer to be adjusted between 0° (normal) and 180° (inverted). low pass (Hz) Adjusts the point as which higher frequencies are filtered from the subwoofer. power mode When set to auto (default) the subwoofer will automatically switch on when a signal is present. After 10 minutes the subwoofer will switch into standby if no signal is present. loop through Line level (unfiltered) ouput.
positioning The most ‘obvious’ position for your subwoofer is not always the best The bass produced by a subwoofer is omnidirectional and very hard for your ears to localise. Therefore a subwoofer can be placed virtually anywhere in your listening room and provide the impression that the bass is radiating from your main speakers. The quality of bass however is affected by the position of your subwoofer due to complex acoustic interactions with your listening room.
connection & calibration - AV receiver connection and defaults advanced connection methods: It is recommended that you use Line Level RCA connections for home theatre applications. • one subwoofer - stereo connection If your receiver has a stereo L & R subwoofer output feature, connect both L & R outputs to your subwoofers L & R line inputs. Ensure the main power switch is off and connect the mains power cord. • Set volume on your subwoofer to middle position. • Set phase to 0°.
connection & calibration - stereo system defaults calibration • Ensure the main power switch is off and connect the mains power cord. • Set volume on your subwoofer to middle position. It is beneficial to select music that is familiar to you when carrying out listening tests and calibration procedures. As a suggestion play clean unprocessed recordings that use double bass, bass guitar, cellos, organ or kick drum etc that cover a wide bass spectrum. • Set phase to 0°.
specification and features additional features Seismix Cube V2.0: specifications Symetrix Vent The Seismix subwoofer enclosure features Symetrix bass reflex venting, with the vent exhibiting the same flare radius internally and externally. This lowers subwoofer distortion and serves to reduce vent turbulence or “chuffing” at high drive levels.
Krix Loudspeakers Pty Ltd 14 Chapman Road Hackham SA 5163 Australia T 61 8 8384 3433 F 61 8 8384 3419 listen@krix.com Rev #10006 krix.com Please read these important safety instructions before you plug in this equipment. Please retain these instructions for future reference. This equipment is manufactured to a very high standard and it should give you many years of reliable service.