KP Electronic Systems, Ltd. WER2 – User Manual Rev: 0.2 KP Electronic Systems, Ltd.
KP Electronic Systems, Ltd. WER2 – User Manual Rev: 0.2 Revision History: Rev. Date Description Reason of change Affect Paragraph/ Initiator Documents 0.1 0.
KP Electronic Systems, Ltd. WER2 – User Manual Rev: 0.2 Contents 1. General:................................................................................................................................................. 4 2. Radio Specification:............................................................................................................................... 4 a. General .....................................................................................................................
KP Electronic Systems, Ltd. WER2 – User Manual Rev: 0.2 1. General: The WER2 is used a water meter register that includes a magnet accelerator countin, LCD displpay, sensors e.g. tilt and RF modem which holds the RF communication between he RMR and the metering devices. The interface with the PC is done through wireless 2.4GHz short range communication. The WERE2 radio is high power 1W UHF radio covers the 430 to 470MHz RF band. The WER2 is power from 2 AA bateris which are connected in serial. 2.
KP Electronic Systems, Ltd. WER2 – User Manual Rev: 0.2 3. LCD Display The LCD (Lquid Crictal Disply) is special & customized FSTN/TN low power LCD. The LCD includes 11 numbers fo meter consumption, and severak icons which show the neter stsus aws it is shown in the next picture. 4. Parameter setting The parmater setting is available in wireless connection (2.4GHz short range). A special 2.
KP Electronic Systems, Ltd. WER2 – User Manual Rev: 0.2 accepted by the user then the RF radio link is established. The WER2 upload all the unit parametrs (see next chepters). The user can changed and dowenlods the new parameters. a. General Setting The General Setting includes the power modes: Power On and Flight Mode. The Flight mode is for transportation or storage for long periode of time. The Flight Mode keeps the unit in the lowest level of current consumer.
KP Electronic Systems, Ltd. WER2 – User Manual Rev: 0.2 c. Meter Setting Meter Setting parametrs includes: The Meter Value - it is the current water consumption figure. The meter Factor which is defined for each type of meter (there are 4 paramters for each flow rate). Ther Factor is the pulse/liter parameters. The Type parameter defines on of many meters.
KP Electronic Systems, Ltd. WER2 – User Manual Rev: 0.2 5. Unit disassembly 6. Warning Statements THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. THE DEVICE COMPLIES WITH THE MINIMUM PERMISSIBLE EXPOSURE (MPE) LIMITS REFERENCED IN 47 CFR 1.1310 Table 1.
KP Electronic Systems, Ltd. WER2 – User Manual Rev: 0.2 NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.