User's Manual

J9

Meter
Input Cables
MTU150W™
Long-Range
Synthesized Radio
Meter Transmitter

Web Site: www.kpsystems.com

ISRAEL Office
Email: [e-mail]
Tefen Industrial Park, Tefen 24959
Tel: [phone] Fax: [phone]
USA Office:
KP ELECTRONICS INC.
Email: [e-mail]
109 Tudor Drive, North Wales, PA 19454
Tel: [phone] Fax: [phone]
Book
096
Approved: Amir S. Rev:
New

MTU150W™ General Description
MTU150W™ is a long-range, synthesized
radio-metering transmitter in the VHF 450-
470 MHz frequency range.
When the MTU150W detects pulse
conditions at one or more of its inputs the
pulse is counted and saved.
When the number of the pulse is equal to the
Trans Scale defined by the GUP10™, it is
then transmitted to the central station
according to the WAT-NET
TM
protocol
selected for the system in operation.
MTU150W™ has one connector (see Figure
1).
1. J9: The 10-pin programming jack is a
serial port to connect a PC or a FTU (see
Figure 1).
Unit parameters and meters values
are easily programmed using
Gup10™ utility-programming
software. (See the MTU150W™
Programming Guide) or by the FTU.
2. Meter Input: The meter input is a two
wires cable. These wires connect to the
meter output.
Figure 1: MTU150W™ View
Preparing for Operation
Before installing the MTU150W™
on site, perform the following
preparations:
1. Setting communication
parameters
2. Self test
Setting Communication
Parameters

Connect GUP10 program to the
MTU150W™ (see the
MTU150W™ programming
guide)
Self-Test
In order to perform a self-test please
see the Field Programmer User
Guide.
Installing the MTU150W
There are two mounting methods:
1. Wall mounting
2. On-Pipe mounting
Wall Mounting Installation
1. Fasten the mounting bracket on
the wall with four screws (See
figure 2)
2. Slide the MTU150W unit on the
mounting bracket until the 4 clips
are locking the unit
3. Define the parameters with the
field programmer (FTU100) see
the FTU User Guide
4. Insert the terminator to J9 (See
figure 1)
5. Put the cover
On-Pipe Mounting Installation
1. Fasten the mounting bracket
on the pipe with two screws
and the “Omega” bracket
(See figure 3)
2. Slide the MTU150W unit on
the mounting bracket until
the 4 clips are locking the
unit
3. Define the parameters with
the field programmer
(FTU100) see the FTU User
Guide
4. Insert the terminator to J9
(See figure 1)
5. Put the cover
Figure 

: Wall Mounting
Figure



: On-Pipe Mounting