Technical Specification BSR100N™ Programming Guide General Band Frequency Range Channel Spacing Programming FCC rules and reg. under Using KP’s GUP5000™ Utility Program, the BSR100N™ parameter values listed below can be programmed or modified. An RSINT001 adapter connects between BSR100 and a PC (see Figure 3). Transmit frequency (MHz) Receiver frequency (MHz) TX time out (0-240 sec.
RF Exposure Requirements General information: Device category: Fixed per description in Part 2.1091 Environment: Uncontrolled Exposure Fixed devices that operate under Part 90 of this chapter are subject to routine environmental evaluation for RF exposure prior to equipment authorization or use. Antenna: The transceiver is designed to be installed only in sites where the antenna installation sites are outdoor fixed mounted locations.
Frequency: 150- 174 MHz The conducted power output is 10 Watts. The coax loss was taken as 1.0 dB. Antenna gain was taken as 3 dBi 100% Duty Factor Power Density = S= 0.2 mW/cm2 W power in Wat ts 10 D 1 Duty Factor in decimal % (1=100%) 1 f or FM 0.
Conclusion: For a transmitter operating with the above criteria the separation distance should be no less than 80 cm or 2.6 ft between the antenna, including any radiating structure, and any persons when normally operated. Other operating conditions should follow a procedure like that shown above and following the guidelines such as those in FCC document OET-65.