Integration Instructions

4-9-1 TENJIN-CHO, KODAIRA-CITY, TOKYO 187-0004 JAPAN TELEPHONE:+81-42-341-3115 TELEFAX:+81-42-345-2015

FCC Modular Integration Instructions

KOYO ELECTRONICS INDUSTRIES CO. LTD., FCC ID: 2AVNJ-0001 is seeking modular approval.

The radio meets the requirements for modular approval as detailed in (reference FCC 15.212 and

FCC KDB 996369) and (Specification: FCC 15.247).

2.2 List of applicable FCC rules

“C2-CPU RADIO BOARD” is tested to below:

47 CFR § FCC 15.247 - Operation within the bands, 2412–2484 MHz

Type of Radio: 802.11bgn SISO radio with 2 antenna type(s) and 1 antenna port(s)

Exposure Condition: Used FURTHER than 20 cm from the head and torso and extremities

Certification: Full (Single) modular approval (reference FCC 15.212 and FCC KDB 996369)

2.3 Summarize the specific operational use conditions

Below antennas are to be used with “C2-CPU RADIO BOARD”

2.4 Limited module procedures

Not applicable. “C2-CPU RADIO BOARD” is certified as Single Modular Approval.

2.5 Trace antenna designs

Not applicable. “C2-CPU RADIO BOARD” uses external antennas please refer to section 2.3.

AntennaInfo Antenna1 Antenna2

Manufacturer TAOGLAS TAOGLAS

Specification File Name GW.26.0151.pdf

G30.B.108111.pdf *1

Model number(Manufacturer) GW.26.0151

G30.B.308151.ha

Model number(AutomationDirect.com) SE-ANT210 SE-ANT250

Gain (dBi) Less than 1.8dBi Less than 1.5dBi

Description(e.g. dipole, yagi, patch, etc.)

Monopole

(Direct Mount)

Monopole

(Panel Mount)

Radiation

Omni-directional Omni-directional

Cable N/A 3m(9.8ft)

Connector type. RP-SMA RP-SMA

*1:There is two change from "G30.B.108111" to "G30.B.308151.ha"

Change1:"G30.B.308151.ha" is "G30.B.108111" of connector changed from SMA to RP-SMA.

Change2:"G30.B.308151.ha" of cable length is 3m(9.8ft) "G30.B.108111" is 1m(3.3ft)

Specifications are the same except for connectors

PAGE 1
FCC Modular Integration Instructions KOYO ELECTRONICS INDUSTRIES CO. LTD., FCC ID: 2AVNJ-0001 is seeking modular approval. The radio meets the requirements for modular approval as detailed in (reference FCC 15.212 and FCC KDB 996369) and (Specification: FCC 15.247). 2.2 List of applicable FCC rules “C2-CPU RADIO BOARD” is tested to below: 47 CFR § FCC 15.247 - Operation within the bands, 2412–2484 MHz Type of Radio: 802.
PAGE 2
.6 RF exposure considerations "C2-CPU RADIO BOARD" is used as the CPU board of the programmable logic controller. Customers use it basically as follows: When used in a steel control panel, use Monopole (Panel Mount) fo SE-ANT250. Otherwise, use Monopole (Direct Mount) of SE-ANT210. 2.7 Antennas “C2-CPU RADIO BOARD” uses external antennas please refer to section 2.3. 2.
PAGE 3
2.9 Information on test modes and additional testing requirements 1)Bluetooth Host(CLICK PLUS CPU) into the pairing mode(provisioning mode) following method. (1)Factory default condition (2)Press and hold the pairing button for 3 seconds during Host(CLICK PLUS CPU) is in STOP Mode. The pairing button is located at the end of the hole and cannot be pressed with a finger. 2)Wireless LAN Use the following method to set the Wireless LAN SSID and password. (1)Koyo provide iOS and Android application.