Installation Instructions

ManualsBrandsKova ManualsElectronicsWIRELESS LIGHT SWITCH

Wireless Light Switch Installation

Instructions (No Provisioning)

This manual and information contained herein applies to the following devices only:

Battery Powered Dimming Light Switch (32120001)

Battery Powered Light Switch (32120002)

Introduction

Package Contents:

 Battery powered light switch

 2 #6-32 screws

 2 yellow wire nuts

 Flush mount kit

 Drywall template

Warning

This switch is powered by three CR2032 lithium-ion batteries.

Use only batteries approved by the manufacturer.

Risk of fire or explosion if the battery is replaced by an incorrect type.

Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that

can result in an explosion;

Leaving a battery in an extremely high temperature surrounding environment that can result in an

explosion or the leakage of flammable liquid or gas; and

A battery subjected to extremely low air pressure that may result in an explosion or the leakage

of flammable liquid or gas.

Do not ingest battery, Chemical Burn Hazard

This product contains a coin / button cell battery. If the coin / button cell battery is swallowed, it

can cause severe internal burns in just 2 hours and can lead to death.

Summary of content (4 pages)

PAGE 1
Wireless Light Switch Installation Instructions (No Provisioning) This manual and information contained herein applies to the following devices only: Battery Powered Dimming Light Switch (32120001) Battery Powered Light Switch (32120002) Introduction Package Contents:      Battery powered light switch 2 #6-32 screws 2 yellow wire nuts Flush mount kit Drywall template Warning This switch is powered by three CR2032 lithium-ion batteries. Use only batteries approved by the manufacturer.
PAGE 2
Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention Turning on the Device To power the light switch simply remove the three pull tab isolators from the switch body Installation Once the isolator tabs have been removed the switch is ready for installation.
PAGE 3
Flush Mount Box If the switch will be mounted to the surface of the drywall using the flush mount box, use the following procedure: Attach the flush mount frame to the wall using the provided hardware. Insert the wireless switch into the frame and use the provided screws to connect the switch to the frame. Use the pinhole on the back of the switch to determine the up orientation - the pinhole should be on the top side when installed correctly.
PAGE 4
(2) this device must accept any interference received, including interference that may cause undesired operation. Warning To satisfy FCC/ISED RF exposure requirements for mobile transmitting devices, a separation distance of 20.0 cm or more should be maintained between the antenna of this device and persons during device operation. To ensure compliance, operations at closer than this distance is not recommended.