User Manual

1 1
2
4
2
3
3
Quick Start Instructions
Transmitter
AC Adapter
Headset
Headset Stand
Infrared LEDs
Headphone
Adapter
Connect the transmitter to your television or audio device.
Setting Up the System
Operating the System
AC Adapter Jack
Ear Pieces
Power
Switch
Power
Indicator
Light
Battery Compartment
Left
Volume
Control
Right
Volume
Control
Infrared
Sensors
Place the transmitter at/ or close to your eye level while
seated. There should be nothing obstructing the transmission of
the infrared light rays from the transmitter to the receiver in
your headset. The transmitter must be within 18 feet (6
meters) of the headset for the system to work properly.
The transmitter will automatically turn on when the AC
adapter is plugged in and when audio signed is detected. Turn
the headset on by sliding the power switch to the “ON”.
Turn the headset off after each use.
Put the headset on. The headset should hang under your
chin with the “ ” logo facing away from you (refer to
figure below). Adjust the volume for each ear to a comfortable
listening level using the volume control dial.
NOTE: The transmitter will go into sleep mode after 3
minutes if no audio signal is detected. To prevent possible
damage to your hearing, please reduce the volume controls to
the minimum level before putting on the headset .
Plug the AC adapter into the jack marked “12VDC” on the
back of the transmitter and plug the adapter into an
electrical outlet.
The headset requires two AAA batteries (not included).
To access the battery compartment, remove the battery
cover on the back side of the headset . Insert two AAA
batteries.
C
C
C
BB
B
B
B
B
B
B
B
B
A
A
A
A
A
A
A
A