KK-3003_Development_Guide Ver_1.0.0 KK-3003 Development Guide FCC ID: 2AJZ4-KK3003 IC: 23777-KK3003 Version：Ver_1.0.
KK-3003_Development_Guide Ver_1.0.0 Contents Module photo .................................................................................................................................... 3 Basic parameters ............................................................................................................................... 3 Pin Definitions ..................................................................................................................................
KK-3003_Development_Guide Ver_1.0.0 Module photo Figure 1 : Module physical map Figure 2 : Module size chart Basic parameters Name Function WIFI IEEE 802.
KK-3003_Development_Guide Ver_1.0.0 CPU frequency 160MHz (Max) Operating System FreeRTOS FLASH 1MB RAM 128KB Peripherals UART/IIC/SPI Number of GPIO pins 10 Dimension (mm) 26.9 x 20.3x 1 Increase according to demand Pin Definitions No. Function TOP A1 GND power supply , Ground A2 VCC_33 power supply , 3.
KK-3003_Development_Guide Ver_1.0.0 B7 CHIP_SLEEP power-up must be pin floating or Pull-up When Pull-down,operating in the sleep mode, which enables low-power consumption Integrated Applications Solution 【Hardware integration】 Leave a 1.2mm slot on the original control circuit board, insert the module into the slot, and solder the wave solder to the circuit board; The original control board supplies 3.
KK-3003_Development_Guide Ver_1.0.0 operational. If a host was previously authorized as an unintentional radiator under the Declaration of Conformity procedure without a transmitter certified module and a module is added, the host manufacturer is responsible for ensuring that the after the module is installed and operational the host continues to be compliant with the Part 15B unintentional radiator requirements.
KK-3003_Development_Guide Ver_1.0.0 IC caution: This device complies with Industry Canada licence-exempt RSS standard(s). Operation is Subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Lors de l'utilisation du produit, maintenez une distance de 20 cm du corps afin de vous conformer aux exigences en matière d'exposition aux RF.
KK-3003_Development_Guide Ver_1.0.0 French : Cet appareil est conçu uniquement pour les intégrateurs OEM dans les conditions suivantes: (Pour utilisation de dispositif module) 1. L'antenne doit être installée de telle sorte qu'une distance de 20 cm est respectée entre l'antenne et les utilisateurs. 2. Le module émetteur peut ne pas être coïmplanté avec un autre émetteur ou antenne. Tant que les deux conditions ci-dessus sont remplies, des essais supplémentaires sur l'émetteur ne seront pas nécessaires.
KK-3003_Development_Guide Ver_1.0.
