User's Manual

E0 78100110
1. Make sure the printer is turned off (The pressed down side of the power switch with "O"
mark denotes the power is off).
2. Make sure the voltage of the electrical outlet matches that of AC adapter.
3. Plug the AC adapter into printer’s power supply inlet.
4. Plug one end of the power cord into the AC adapter, and then plug the other end of the power
cord into the electrical outlet connecting the ground properly.
Connecting the Ethernet interface:
Plug the crystal end of the Ethernet interface (RJ-45) into the printer’s Ethernet interface, and
plug the other end into the LAN s entrance.'
Connecting the USB interface:
Can be connected with the following type: keyboard, mouse, USB, bar code scanner, receipt
printer etc.
Connecting method: Plug the A end of the USB cable into the printer s USB interface
connector.
'
Note: 1. Please use the cash drawer that meets the requirement of the
specification. Manufacturer will not honor warranty when using
unauthorized cash drawer.
2. Make sure the printer is off before connecting the cash drawer. Only
after tightening the cable may you turn on the printer, or the printer
may be damaged.
Caution: 1. If the rated voltage doesn't match the outlet voltage, do not plug
in the power cord. Or else the printer may be damaged or work
improperly.
2. Please use the electrical outlet connecting the ground properly.
3. Please use the original AC adapter only. Manufacturer has no
responsibilities for the problems which are led by using
unauthorized AC adapter.
Connecting the cash drawer interface:
Cash drawer specification: interface type RJ-11, drive voltage 24V (DC), current<1.0 A.
Connecting method: Make sure the power of the printer is off then plug the cash drawer cable
into the cash drawer interface.
Connecting the earphone or sound box:
Connector type of the connecting wire:3.5mm TRS.
Connecting method: Turn off the printer. Plug the connector of the earphone or sound box
connecting wire to the printer s audio interface.'
Note: This printer is series model type and different model may be equipped with
different network communication module and interfaces. Different model may be
equipped with different interface. Please take the specific interface as standard.
1 Open the packing box and take out the network billing printer.
2. Save all the packing materials so that they can be used when transporting the printer in the
future.
.
1. When inserting, please insert the cards properly to the SIM card socket and TF card socket in
the direction of the arrow shown on the socket.
2. When removing, press down the card once then the card will pop up a part, then take out the
SIM card and TF card from the sockets.
Ethernet interface
USB interface
Cash drawer interface
Facility User's Guide
Network billing printer
Power cord
Facility user s guide'
AC adapter
Rear cover
Front cover
Buttons
Paper feed roller
Power switch
Touch screen
Thermal mechanism
Paper holder
TF card socket
SIM card socket
Roll paper guide
2. Removing the Protective Materials
3. Main Parts of the Printer
1. Unpacking & Checking
Read all of these instructions carefully before using the printer.
Caution: This touch screen is the glass type and is fragile. Please be more careful
when using and avoid hitting. Manufacturer will not honor warranty for
the screen damage which lead by improper usage.
Cash drawer interface
Ethernet interface
Power supply inlet
USB interface
Audio interface
USB interface
5. Connecting the Power Cord
O
I
Power supply inlet
AC adapter
Power cord
Power switch
4. Inserting and Removing the SIM card and TF card
6 Connecting Other Equipments.