How to Guide

Product Information
Applicable product:
Shower and valve trim with NPT diverter
spout
K-T395-4
Shower and valve trim with slip-fit diverter
spout (shown)
K-T395-4S
Shower and valve trim K-T396-4
Valve trim K-T397-4
Rite-Temp
®
valve must be ordered to complete faucet.
Applicable bath spout:
Non-diverter bath spout K-373
Slip-fit non-diverter bath spout K-373-S
Diverter bath spout K-389
Slip-fit diverter bath spout K-389-S
Required accessories:
Rite-Temp
®
valve OR K-304-*
HiFlow Rite-Temp valve with stops K-2971-KS
* For a complete listing of all the Rite-Temp valves, refer
to the K-304-* Specification sheet or Roughing-In sheet.
Installation Notes
Install this product according to the installation guide.
Install the Rite-Temp
®
valve according to the valve installation
guide.
NOTICE: Risk of product damage. Long screws, for
installing trim, can damage the K-2971-KS valve. Consult the
trim installation guide to verify if the thin wall installation kit
(88526) is needed.
Avoid cross-flow conditions. Do not install shut-off device on
either valve outlet.
Cap shower outlet if deck-mounted spout, diverter, or
handshower is connected to the spout outlet.
Install straight pipe or tube drop of 7″ (178 mm) to 18″
(457 mm) with single elbow between valve and wall-mount
spout.
1/2" NPT
1/2" Hot
1/2" Cold
4-7/16" (113 mm)
Ø 7" (178 mm)
5-1/2"
(140 mm)
72" (1829 mm) - 78" (1981 mm)
to Floor (Typical)
5-5/8"
(143 mm)
4" (102 mm)
to Top of Rim
10"
(254 mm)
48" (1219 mm)
to Floor
(Shower Only)
For slip-fit spout, 5/8" OD tube must
extend 1-1/2" (38 mm) min to 2-7/8"
(73 mm) max beyond the finished wall.
For 1/2" NPT spout, pipe must extend
3-3/4" (95 mm) beyond the finished wall.
2-3/4" (70 mm) Thin Wall
3-1/2" (89 mm) Thick Wall
Complete bath and shower faucet with Rite-Temp valve and
slip-fit diverter spout shown.
Roughing-In
K-T395, K-T396, K-T397
DEVONSHIRE
®
RITE-TEMP
®
PRESSURE-BALANCING BATH/SHOWER VALVE TRIM
DEVONSHIRE
®
RITE-TEMP
®
PRESSURE-BALANCING BATH/SHOWER VALVE TRIM
1012741-1-
F