Installation & Assembly
Measure distance “A.” Subtract 1/4” (6 mm) or
the width of a number 2 pencil from “A” and cut
the boom track.
Position the boom track on the center of the
ledge. If needed, le the ends to match the
corners.
Center the boom track on the ledge with the leg
to the outside. Tape the boom track in place and
mark the position.
IMPORTANT! The boom track and wall jamb
must sit at against the bath/shower ledge and
the wall. If needed, trim and le the wall jamb.
Use a coin to match and to transfer the corner
radius of the bath/shower to the wall jamb.
Position the wall jambs over the boom track.
Plumb both wall jambs. Mark the screw holes.
Insert the bumpers into the top and boom holes
of the wall jamb. Drill 1/8” pilot holes into the
walls using the bumpers as a guide.
Remove the wall jambs and bumpers. Drill 5/16”
holes into the walls and insert the anchors.
Apply silicone sealant in the groove on the
underside of the boom track. Secure the boom
track to the ledge along the marked location.
Reposition both wall jambs. Secure the wall
jambs with screws. Aach a bumper at the top
and boom locations.
Check the bumpers for the correct horizontal
alignment with the wall jambs.
Sliding Bath Doors Sliding Shower Doors
11414861-2-A
1414861-2-A
Installation Instructions
Required Tools Parts Identification
2 3 4
7 86 9
1 5
10
WARNING: Risk of serious injury. Damage prior to installation can
result in glass shaering. Inspect the glass and all parts for damage
before installation.
WARNING: Risk of serious injury. Improper installation can result
in glass shaering. Follow all installation instructions.
WARNING: Risk of serious injury. Do not cut tempered glass.
Tempered glass will shaer if cut.
WARNING: Risk of serious injury. Bath/Shower door and side
panels can shaer. Regularly inspect the glass and all parts for
damage, missing, or loose parts.
WARNING: Risk of serious injury. Always wear safety glasses
while cuing and drilling.
IMPORTANT! Do not touch the edges of the tempered glass with tools or
any other hard objects. Do not set the unframed tempered glass directly on
the oor or any hard surface.
IMPORTANT! Leave this manual for the end user.
Read these instructions before installing or using this product.
IMPORTANT! Do not cut the top track the same length as the boom track.
IMPORTANT! Do not remove the boom seal from the glass.
NOTICE: The warranty does not apply to a product that has been modied
or altered in a manner other than as expressly permied in the Installation
Instructions.
Walls must be within 3/8” (10 mm) of plumb.
Cover the drain with tape to avoid loss of small parts.
Follow the silicone sealant manufacturer’s instructions for application and
curing time.
Critical Information!
Read Before Installation!
Read and follow all instructions.
USA/Canada: 1-800-4KOHLER
México: 001-800-456-4537
kohler.com
Finish/color code must be specified when ordering.
Retain this document for future servicing.
Record model number from box for reference.
Model Number:______________
1414861-2