Homeowners Guide Toilet PR O O F K-77780 Français, page ″Français-1″ Español, página ″Español-1″ 1288209-5-A
Important Information READ AND FOLLOW ALL INSTRUCTIONS Important Safeguards WARNING: To reduce the risk of burns, electrocution, fire, or injury to persons: DANGER: Risk of electric shock. Connect only to a circuit protected by a Ground-Fault Circuit-Interrupter (GFCI)*. WARNING: Risk of personal injury. UV light emitted from this light can cause injury to skin or eyes. Avoid exposure to unshielded lamp. F WARNING: Risk of personal injury.
Remote Control Compliance (cont.) 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. PR O O F NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Rear Wash Dryer Light Level Sensor Front Wash Stop Bidet Wand Seat Sensor Area PR O O Actuation Switch F Manual Controls Features - Toilet NOTE: Many of the features listed here can be adjusted, enabled or disabled using the remote control. Specific directions for these procedures are listed later in this manual. General Features Automatic Flushing - When enabled, this feature automatically flushes the toilet after the user stands up, lowers the seat, or leaves the area 60 seconds after use.
Features - Toilet (cont.) Front/Rear Wash - Front and rear wash feature adjustable positioning, adjustable water temperature, adjustable water pressure, and pulsate and oscillate water action. Dryer - The dryer features adjustable air temperature. PR O O F UV Sterilization - The sterilization feature uses ultra violet rays and sterilized water to clean the bidet wand when enabled. It will begin operation only when the seat is closed. Kohler Co.
F PR O O Features - Remote Control Top of Remote Control Start - Press to activate the remote control when it is inactive. Press it a second time to turn the remote control off. Remote Control Functions Stop - Press the ″stop″ icon to stop bidet operation. Press and hold to turn off the remote control. Front Wash - After sitting down, press ″front″ to activate the front wash. This feature will stop automatically after 5 minutes or can be stopped by selecting the ″stop″ icon.
Features - Remote Control (cont.) Dryer - While seated, press the ″dryer″ icon to activate the dryer. This feature will stop automatically after 4 minutes or can be stopped by selecting the ″stop″ icon. Deodorizer - While seated press ″deodorizer″ icon once to activate the deodorizer feature. Press it a second time to stop the feature. Water Temperature - While seated press the ″water temp″ then press the ″+″ or ″–″ icons to adjust the water temperature when the bidet features are in use.
Rear Wash Dryer Light Level Sensor Front Wash Stop Bidet Wand Seat Sensor Area PR O O Actuation Switch F Manual Controls Manual Operation The basic functions of the toilet can be controlled manually using the buttons located on the right side of toilet. NOTE: When the manual bidet features are activated using the manual buttons, they will default to the middle temperature, pressure, and position settings. Dryer - Press the ″DRYER″ icon to activate the dryer.
Rear Wash Dryer Light Level Sensor Front Wash Stop Bidet Wand Seat Sensor Area PR O O Actuation Switch F Manual Controls Flushing Your Toilet When automatic flush is activated, the toilet will automatically flush 60 seconds after the user stands up. To flush the toilet using the remote control, press the ″flush″ icon. To flush the toilet manually, press the silver actuator. To flush the toilet during a power outage, pour a 2 gallon bucket of water into the bowl. Kohler Co.
F PR O O Using the Bidet Wash Functions NOTE: The bidet function will automatically stop after 5 minutes. Using the Front Wash Press the [On/Off] button. Press the ″front″ icon. Press the ″stop″ icon to end. Using the Rear Bidet Wash Press the [On/Off] button. Press the ″rear″ icon. Adjusting the Water Pressure NOTE: Adjust the water pressure while the rear or front wash are in use. Press the ″pressure″ icon. Press the icon as needed to increase or decrease the water pressure.
Using the Bidet Wash Functions (cont.) Press the icon as needed to increase or decrease the water temperature. There are five settings available. The blue points to the left of the icon indicate the setting the water temperature is on. Adjusting the Wand Position NOTE: Adjust the wand position while the rear or front wash are in use. Press the ″wand″ icon. Press the icon as needed to increase or decrease the wand position. There are five settings available.
F PR O O Advanced Feature Settings Set each of the features to your desired settings. Features to set include: Automatic Flush Press and hold the ″dryer″ icon until a short beep is heard. Release the icon after the night light flickers three times. Press and hold the ″flush″ icon to change the setting. The night light will flash quickly and a short beep will sound when automatic flush is activated. The night light will flash slowly and a long beep will sound when automatic flush is deactivated.
Advanced Feature Settings (cont.) The night light will flash once quickly and a short beep will sound when the sensor is set to near. The night light will flash twice quickly and a short beep will sound when the sensor is set to mid-distance. The night light will flash three times quickly and a short beep will sound when the sensor is set to long distance. The night light will flash quickly and a long beep will sound when the sensor deactivated.
On/Off cover rear front massage water temp seat temp sanitize spiral pressure dryer deodorizer wand PR O O seat flush F stop Remote Control to Toilet Connection Pair the Remote Control IMPORTANT! The remote control cannot be paired to the toilet when the toilet is occupied. NOTE: If the remote control is out of range of the toilet, the icons on the bottom row will flash automatically.
F PR O O Using the Dryer and Deodorizer Using the Dryer Press the ″dryer″ icon. Press the icon as needed to increase or decrease the dryer . There are five settings available. The blue points to the left of the icon indicate the setting the dryer is on. Activating the Deodorizer Press and hold the ″seat″ icon. The night light will blink once quickly when the deodorizer is activated. The night light will blink once slowly when the deodorizer turns off.
Water Cartridge PR O O F Cover Filter Servicing the Toilet Servicing the Water Purification Cartridge NOTE: The water purification cartridge is nearing end of life when the orange LED light on top is flashing. The cartridge should be replaced when the Order the replacement cartridge at Kohler.com. Remove the back cover using the provided tool or a _____________. Remove the water purification cartridge by turning it counter clockwise. Thread the replacement air filter into place.
F PR O O Manual Clean Settings Cleaning the Bidet Wand NOTE: Use a soft bristle brush to clean the bidet wand. On the manual control panel, simultaneously press and hold down the ″REAR″ and ″FRONT″ buttons until the wand extends out. Clean the wand with a wet soft bristle brush and appropriate cleaner. On the manual control panel, hold down the ″STOP″ button until the wand retracts. Cleaning or Replacing the Filter Disconnect the power to the toilet. Turn off the water supply.
Replacing the Batteries NOTE: The red light in the docking station will blink to indicate low batteries in the docking station. The ″stop″ icon will blink on the remote control when it has a low charge and should be returned to the docking station. If the remote control is secured to the docking station, remove it and set it aside. Remove the docking station from the wall. Open the back compartment of the docking station by simultaneously sliding both tabs to the right and removing the cover.
Troubleshooting (cont.) Symptoms A. There is no water being supplied to the toilet. The toilet has power, does not respond. B. The pump connection has not been made properly. C. The level switch is not properly connected. D. The actuation assembly does not work. A. The actuation switch is not properly connected. B. As the toilet is powering off, before the prompt sound has stopped, the power was turned on again. A. The water supply stop is closed or only partially open. D.
Troubleshooting (cont.) Symptoms 12. The night light does not turn on in low light conditions. Probable Causes A. Night light is not enabled. B. Low light sensor is not working properly. Recommended Action A. Enable the night light feature using the remote control. B1. Clean the light sensor located on the manual control panel. B2. Call the Customer Care Center using the information provided on the back page of this manual.
Homeowners Guide PR O O F Toilet 1288209-5-A
Informations importantes LIRE ET SUIVRE TOUTES LES INSTRUCTIONS Mesures de sécurité importantes AVERTISSEMENT: Pour réduire le risque de brûlures, d’électrocution, d’incendie ou de blessures personnelles: DANGER: Risque de choc électrique. Raccorder uniquement à un circuit protégé par un disjoncteur de fuite de terre (GFCI)*. AVERTISSEMENT: Risque de blessures. La lumière ultraviolette émise par cette lampe peut créer des lésions oculaires ou de la peau. Éviter toute exposition à une lampe non blindée.
Conformité de la télécommande ID FCC: N82-KOHLER019, N82-KOHLER020 IFT: Certification Number RCPKO1215-2233 and RCPKO1215-2234. Cet appareil est conforme à la section 15 des réglementations de la FCC. Le fonctionnement de l’appareil est soumis aux deux conditions suivantes: 1. Cet appareil ne doit pas provoquer d’interférences néfastes, et 2. Cet appareil doit tolérer les interférences reçues, y compris celles qui risquent de provoquer un fonctionnement indésirable.
F PR O O USA/Canada: 1-800-4KOHLER México: 001-800-456-4537 kohler.com ©2016 Kohler Co.
