Installation and Care Guide

1241239-2-A Kohler Co.
Hardware Placement Guide
1-5/16" (33 mm)
3-3/8"
(86 mm)
Door Pull
Location
Drawer Pull
Location
3-3/8"
(86 mm)
Ø 3/16"
Drill Through
Ø 3/16"
Partial Drill
5/8"
(16 mm)
Centered
Side to Side
Hardware Placement for K-99687
□□ Measure and mark the dimensions for the hardware on the drawers and the doors.
□□ Measure and mark 5/8” (16 mm) directly below each initial mark.
□□ Drill a 3/16” (21 mm) hole all the way through each top markings.
□□ For each boom marking, drill a 3/16” (21 mm) hole 1/4” (6 mm) deep. Do not drill all the way
through.
□□ Insert a screw through the top hole from the inside. Count the number of visible notches on the
screw that appear from the other side.
□□ Remove the screw and using a pair of side cuers, cut the screw at the appropriate notch. Repeat
for each screw.
□□ Insert a screw through a hole, and align with a handle. Thread the handle onto the screw. Repeat
for each handle.