Rough In Guide

Product Information
Applicable product:
Bath whirlpool with heater and integral
apron, left drain
K-1124-HL
Bath whirlpool with heater and integral
apron, right drain
K-1124-HR
Fixture*:
Bathing well
Basin area, bottom 51-3/8″ (130.5 cm) x 21″ (53.3 cm)
Basin area, top 64-1/2″ (163.8 cm) x 30-1/2″
(77.5 cm)
Weight 140 lbs (63.5 kg)
To overflow
Water depth 15″ (38.1 cm)
Capacity 72 gal (273 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7
Heater: kW V Hz A
1.5 120 60 12.5
Pump is supplied with 24″ (61 cm) grounding-type plug-in
cord.
Required accessories:
Clearflo slotted overflow brass bath drain OR K-7271
Clearflo slotted overflow bath drain – PVC pipe K-7272
Required Electrical Service
(2 required)
Two dedicated circuits required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI):
Pump/control/Heater 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 43 lbs/square foot (210 kg/square meter) loading.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
Will comply with ADA when installed per Section 607
Bathtubs of the Act.
Fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
36" (91.4 cm)
72" (182.9 cm)
3/4" (1.9 cm)
1-1/2"
Bath Drain
1/2" (1.3 cm) R.
19"
(48.3 cm)
1-1/4"
(3.2 cm)
No change in measurements if connected
with drain illustrated. (K-7272)
18"
(45.7 cm)
1-1/4"
(3.2 cm)
11-1/4"
(28.6 cm)
2-1/2"
(6.4 cm)
Integral Flange
Detail
4-1/8"
(10.5 cm)
Roughing-In
K-1124-HL, K-1124-HR
ARCHER
TM
6’ (1.8 m) BATH WHIRLPOOL WITH HEATER
ARCHERTM 6’ (1.8 m) BATH WHIRLPOOL WITH HEATER
1071367-1-
D