Installation Guide
Tools
• Tape Measure
• Pencil
• Drill and 3/16" Bit
• Side Cuers
Outils
• Mètre ruban
• Crayon
• Perceuse et mèche de 3/16 po
• Couteaux latéraux
Herramientas
• Cinta para medir
• Lápiz
• Taladro y broca de 3/16 pulg.
• Pinzas de corte
4"/ po
(102 mm)
Centered Side to Side
Centré Côte à côte
Centrado lateralmente
Hardware Placement
Measure and mark the aachment locations for the hardware on the drawers.
Drill a 3/16" (21 mm) hole at each marked location.
From inside the drawer, insert a screw through one of the holes. Count the number of visible
notches on the screw that appear from the other side.
Remove the screw and using a pair of side cuers, cut the screw at the appropriate notch. Repeat
for each screw.
Insert a screw through each hole, and align with a handle. Thread the screws into the handle.
Repeat for each handle.
Positionnement de la visserie
Mesurer et marquer les emplacements des aaches pour la visserie sur les tiroirs.
Percer un trou de 3/16 po (21 mm) à chaque emplacement marqué.
À partir de l'intérieur du tiroir, insérer une vis à travers l'un des trous. Compter le nombre
d'encoches visibles sur la vis qui apparaissent à partir de l'autre côté.
Retirer la vis et utiliser une paire de couteaux latéraux pour couper la vis à l'encoche appropriée.
Répéter pour chaque vis.
Insérer une vis à travers chaque trou et aligner avec une une poignée. Enler les vis dans la
poignée. Répéter pour chaque poignée.
1470608-2-A
1 Kohler Co.
1470608-2