Instructions / Assembly

Installation Guide SKU#27944, SKU#27945, SKU27946#
USA / Canada : 1-800-4 KOHLER 1439237-2_B
www.kohler.com
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damages. This product is for indoor use only. Observe all local codes.
Please see next page for a larger installation image
TOOLS AND MATERIALS NEEDED
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put them onto
a clean and soft cloth to protect finish. Confirm all parts are included.
2. Loosen screw (G) and then remove mounting plate (B) from canopy (F).
3. Attach mounting plate (B) onto outlet box with screws (D). Ensure
ground screw (C) is attached to mounting plate (B).
4. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten fixture green or bare ground wire to the green or bare copper
wire in outlet box with wire nut (A) or fasten onto ground screw (C)
on mounting plate (B).
5. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten fixture white wire to the white wire in outlet box with wire
nut (A). Wrap the wire connector with electrical tape so that the
tape seals the end of wire nut (A). See diagram 1.
6. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten the fixture black wire to the black wire in outlet box with wire
nut (A). Wrap the wire connector with electrical tape so that the
tape seals the end of wire nut (A). See diagram 1.
7. Insert quick connector (E) into the opposing quick connector end.
8. Tuck wires carefully inside outlet box. Attach the canopy (F) onto
mounting plate (B) by securing screws (G).
9. Thread light rod (M) onto the bottom of the fixture. Long rod is for
SKU#27944, short rod is for SKU#27945/27946.
10. Remove socket ring (I) from socket (L). Slide bracket (K) over socket
and then secure by threading socket ring (I) back over the socket (L).
11. NOTICE: Do not exceed recommended wattage. Rated Max 60 W,
Type G16.5. Bulb(s) not included. Bulb height must not exceed 3.21”.
12. Install bulb by loosening screws (H) and rotating the shade (J)
towards the wall. Install bulb onto socket (L).
13. To change the angle of the shade (J): Loosen screws (H), reorient the
metal shade (J) to the desired position and then tighten screws (H).
See diagram 2.
14.
To change the direction of the shade (J): Loosen the socket ring (I),
reorient the Metal shade (J) to the desired position and then tighten
socket ring (I). See diagram 3.
15. Repeat steps 9-14 for each additional light.
16. Restore power to circuit at breaker or fuse box.
Approved fastener
(Wire nut)
Electrical tape
Phillips &
Flathead Screwdriver
Wire
Cutter/stripper
Electrical Current
Tester
Electrical
Tape
Vertical (Dashed area):
-75° to 75° rotation
Diagram 1
Diagram 2