Rough-In Guide

ManualsBrandsKOHLER ManualsBathWindward 6 ft. Whirlpool Tub in White

Product Information

Applicable products:

Bath whirlpool with integral ﬂange and

heater – left drain

K-1114-LH

Bath whirlpool with integral ﬂange and

heater – right drain

K-1114-RH

Fixture*:

Bathing well:

Basin area, bottom 55″ (139.7 cm) X 23-1/4″ (59.1 cm)

Basin area, top 64″ (162.6 cm) X 32″ (81.3 cm)

Weight 110 lbs (50 kg)

To overﬂow:

Water depth 15″ (38.1 cm)

Capacity 57 gal (215.9 L)

* Approximate measurements for comparison only.

Drop-in cut-out dimensions:

58-1/2″ (148.6 cm) x 40-1/2″ (102.9 cm)

Pump: V Hz A

1-speed 120 60 7.5

Heater: kW V Hz A

1.5 120 60 12.5

Minimum access panel pump/control:

20″ (50.8 cm) W x 15″ (38.1 cm) H required

Required Electrical Service

(2 required)

Two dedicated circuits required, both protected with a

Class A Ground-Fault Circuit-Interrupter (GFCI):

Pump/control 120 V, 15 A, 60 Hz

Heater 120 V, 15 A, 60 Hz

Locate the outlets behind the whirlpool and within 24″

(61 cm) of the pump and, if supplied, heater.

Installation Notes

Install this product according to the installation guide.

Floor support under the whirlpool must provide for a minimum

of 30 lbs/square foot (142 kg/square meter) loading.

If installing a rim-mount faucet, make sure there is no

interference with the drain overﬂow and circulating system

before drilling any holes. Consult local and national codes for

minimum air gap requirements if installing a spout on the

faucet deck.

Fixture conforms to ANSI Standard Z124.1.2. All dimensions

are nominal.

Roughing-In

K-1114-LH, K-1114-RH

WINDWARD

BATH WHIRLPOOL WITH INTEGRAL FLANGE AND HEATER

WINDWARD

BATH WHIRLPOOL WITH INTEGRAL FLANGE AND HEATER

1047223-1-

Summary of content (2 pages)

PAGE 1
K-1114-LH, K-1114-RH WINDWARD® BATH WHIRLPOOL WITH INTEGRAL FLANGE AND HEATER Roughing-In Product Information Applicable products: Bath whirlpool with integral flange and heater – left drain Bath whirlpool with integral flange and heater – right drain K-1114-LH K-1114-RH Fixture*: Bathing well: Basin area, bottom 55″ (139.7 cm) X 23-1/4″ (59.1 cm) Basin area, top 64″ (162.6 cm) X 32″ (81.3 cm) Weight 110 lbs (50 kg) To overflow: Water depth 15″ (38.1 cm) Capacity 57 gal (215.
PAGE 2
WINDWARD® No change in measurements if connected with drain illustrated. (K-11677 or K-11677M) Recommended faucet area 21" (53.3 cm) 1-1/4" (3.2 cm) 3-3/4" (9.5 cm) 11-1/16" (28.1 cm) 1-1/4" (3.2 cm) Tile Flange Detail Pump/Control Access 1-1/2" (3.8 cm) Drop-In Rim Detail 42" (106.7 cm) 72" (182.9 cm) 1-1/4" (3.2 cm) 21" 19-1/2" (53.3 cm) (49.5 cm) 3-1/2" (8.9 cm) 3/8" (1 cm) 2-7/8" (7.3 cm) 3" (7.