Rough-In Guide

Product Information
Applicable product:
Bath – integral apron,
left drain
K-1114-GLA not shown
Bath – integral apron,
right drain
K-1114-GRA shown
Fixture*:
Bathing well
Basin area
bottom
55″ (139.7 cm) x 23-1/4″ (59.1 cm)
Basin area
top
64″ (162.6 cm) x 32″ (81.3 cm)
Weight 132 lbs (60 kg)
To overflow
Water depth 15″ (38.1 cm)
Capacity 78.5 gal (297 L)
* Approximate measurements for comparison only.
Blower motor Heater V Hz A
300 W 120 60 5
Minimum access panel blower motor:
20″ (50.8 cm) W x 15″ (38.1 cm) H required
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 5 A, 60 Hz
Locate the outlet behind the bath and within 24″ (61 cm)
of the pump.
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 39 lbs/square foot (190 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with the drain overflow and circulating system
before drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
Fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
Recommended faucet area
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
2-7/8" (7.3 cm)
3" (7.6 cm)
3-1/2"
(8.9 cm)
1-1/4"
(3.2 cm)
1-1/4"
(3.2 cm)
Tile Flange
Detail
72" (182.9 cm)
42" (106.7 cm)
1-1/2" OD
1" (2.5 cm) from
the Floor to the
Bottom of the Drain
21"
(53.3 cm)
1-1/4" (3.2 cm)
3-3/4"
(9.5 cm)
21"
(53.3 cm)
11-1/16"
(28.1 cm)
Blower/Control Access
20" (50.8 cm) W x
15" (38.1 cm) H Min
Roughing-In
K-1114-GLA, K-1114-GRA
WINDWARD
TM
BATH WITH AIRJETS, INTEGRAL APRON
WINDWARDTM BATH WITH AIRJETS, INTEGRAL APRON
1079332-1-
B