Installation Guide SonataR Grab Bar And Acrylic Shelf K-9459 Français, Page 5 Español, Página 8 1021774-2-B B 1021774-2-
Thank You For Choosing Kohler Company We appreciate your choosing The Bold Look of Kohler with your plumbing ware selection. Please take a moment to review this manual before you start the installation. Contact us if you have any installation or performance problems. Our phone numbers and website are listed on the back cover. Thanks again for choosing Kohler Company. Introduction - Please read all instructions carefully to familiarize yourself with the required tools, materials and installation procedures.
Shower Wall Bracket Wall Inserts Screw Setscrew Apply Sealant Shelf 1. Shelf Installation IMPORTANT: The wall inserts for the shelf brackets are installed in the bath/shower wall at the factory. - Apply a small amount of silicone sealant to the back of each bracket. - Assemble the brackets and sockethead screws as shown. - Use the hex wrench to install the bracket on the shower wall insert. - Repeat for the other bracket. - Remove any excess sealant from the brackets.
Lock Washer Shower Wall Nut Large Washer Stud Apply Sealant Grab Bar 2. Grab Bar Installation IMPORTANT: Access to the back of the module is required to install the grab bar. The grab bar must be installed before the bath/shower module is moved into place for installation. - Carefully install the studs in the grab bar until the studs bottom in handle. Back the studs out three turns. Failure to back the studs out can cause damage to the grab bar surface.
Guide d’Utilisation Main Courante (Barre d’Appui) et Étagère en Acrylique Merci d’avoir choisi un produit KOHLER Merci d’avoir choisi la ligne The Bold Look de Kohler. S’il vous plait, veuillez lire attentivement ce guide avant de commencer l’installation. N’hésitez pas à nous contacter en cas de problème d’installation ou de fonctionnement Nos numéros de téléphone et notre adresse de site Internet sont au verso. Merci encore d’avoir choisi un produit KOHLER.
Mur de la Douche Support Vis Insère Mural Vis Appliquez le Matériau d’Étanchéité Étagère 3. Installation de l’Étagère IMPORTANT : Les inséres muraux des supports de l’étagère ont été installés sur le mur de la Baignoire / Douche à l’usine. - Appliquez du mastic silicone à l’arrière de chaque support. - Montez les supports et les vis de fixation tel qu’illustré - À l’aide d’une clé hexagonale (Allen) installez le support sur l’insère mural de la paroi de la douche.
Rondelle de Blocage Mur de la Douche Écrou Large Rondelle Tige Filetée Main Courante (Barre d’Appui) Appliquez le Matériau d’Étanchéité 4. Installation de la Main Courante (Barre d’Appui) IMPORTANT : Prévoyez un accès à l’arrière du module pour installer la main courante. Installez la main couranteavant de déplacer le module de baignoire / douche sur le lieu de son installation. - Insérez les tiges filetées dans la barre de support de façon à ce qu’elles émergent.
Guía de Instalación Agarradera y repisa acrílica Gracias por elegir los productos de Kohler Gracias por elegir la línea de productos Kohler, a través de la compra de este producto. Por favor, tome unos minutos para leer este manual, antes de comenzar la instalación. En caso de problemas de instalación o de funcionamiento, no dude en contactarnos. Nuestros números de teléfono y nuestra página web se encuentran en la solapa posterior. Gracias nuevamente por escoger a Kohler.
Pared de ducha Sujetadores murales Aplique sellador Tornillo de fijación Soporte Tornillo Repisa 5. Instalación de la repisa IMPORTANTE: Los sujetadores murales para los soportes de la repisa vienen instalados en la pared de baño/ducha de fábrica. - Aplique una pequeña cantidad de sellador de silicona en el dorso de cada soporte. - Monte los soportes y los tornillos de cabeza hueca tal como se ilustra. - Con una llave hexagonal, instale el soporte en el sujetador mural.
Arandela de seguridad Pared de ducha Tuerca Arandela grande Perno Agarradera Aplique sellador 6. Instalación de la agarradera IMPORTANTE: Es necesario tener acceso a la parte de atrás del módulo para instalar la agarradera. La agarradera debe instalarse antes de desplazar el módulo de bañera y de ducha al lugar de instalación. - Instale con cuidado los pernos en la agarradera hasta que sobresalgan por la manija. Desenrosque los pernos tres vueltas.
Kohler Co.
USA: 1-800-4-KOHLER Canada : 1-800-964-5590 Mexico: 001-877-680-1310 kohler.com E 2003 Kohler Co. 1021774-2-B 12 A 1021774-2- Kohler Co.