Installation & User Guide Dual-Flush Toilet OVE PANACHE OPIAZ PARLIAMENT PERSUADE ESCALE 1102602-A2-D
Tools and Materials Thank You For Choosing Kohler Company We appreciate your commitment to Kohler quality. Please take a few minutes to review this manual before you start installation. If you encounter any installation or performance problems, please don’t hesitate to contact us. Our phone numbers are listed on the back cover. Thanks again for choosing Kohler Company. Before You Begin CAUTION: Risk of personal injury or product damage. Handle with care.
Installation 1 Remove the existing toilet: Turn off the water supply and flush the toilet, then sponge out all remaining water from the cistern. Disconnect the supply shut-off valve (if present), and remove the old pan and cistern. CAUTION: Risk of hazardous gases. If the new toilet is not installed immediately, temporarity stuff a rag in the closet flange. 2 Define the position of connector: Place the connector onto the pan, position between outlet and waste pipe.
Floor fixing option 4 Bracket Drill 3/8” (10 mm) fixing holes at the marked locations on the floor and insert the anchor. Install the washer and insert the hexagon screw into the bracket then tighten the screw. Position the toilet in the installed position. Install the sleeves, tighten the screw and attach the caps. Hexagon Lag Screw Bracket Hole Anchor Washer Anchor Cap Sleeve Screw 5 Screw Drill 5/16” (8 mm) mounting holes at the marked locations. Insert anchors into the holes.
Installation 6 In cistern. OVE PANACHE Tank Hose Stop Valve OPIAZ PARLIAMENT PERSUADE ESCALE Kohler Co.
Tank fixing option 7 Position the cistern on the pan by centering the gasket on the pan inlet. Assemble the retaining washing and sealing washer to the screw. Securely tighten the screw so the cistern is level. * Optional for different product Gasket Screw Plastic* Screw Washer Nut Brass* Retaining Washer Plan Washer Fiber Washer Sealing Washer Screw 8 Connect the supply shut-off valve to the supply hose and connect supply hose to toilet supply shank.
Install the Push Buttons 1 Disassemble the push rods. 2 Using the push rod, measure the 3 Reassemble the push rods. 4 Fit the lid and test the buttons. Adjust Kohler Co. distance between the flush valve and the top of the tank lid. Mark this lengh and cut the push rod to length. Cut the push rod to length. the rods as required.
Install Flush Valve Flush Valve A 1 Release flush valve by turning righ 2 Assembly flush valve by pushing and pull straight up on the canister. straight down into the canister and turning left. 2 1 1 2 Flush Valve B 1 Release flush valve by squeezing 2 Assembly flush valve by pressing it into the flush valve so it snaps into place. the tabs on both side of the canister and pulling straight up out of the flush valve. 1102602-A2-D 8 Kohler Co.
Kohler Co.
1102602-A2-D 10 Kohler Co.
Kohler Co.
CONTACT AND WARRANTY INFORMATION For warranty information, please visit our website Australia www.au.kohler.com. New Zealand www.kohler.co.nz CALL US FOR HELP NEW ZEALAND KOHLER NZ LTD AUSTRALIA KOHLER CO. Free Ph: 0800 564 537 (0800 KOHLER) Free Fax: 0800 664 488 www.kohler.co.nz Free Ph: 1300 658 277 Free Fax: 02 9618 1189 www.au.kohler.