Installation Sheet

Installation Guide SKU#22545
USA/Canada: 1-800-4 KOHLER 1391092_2
www.kohler.com
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damages. This product is for indoor use only. Observe all local codes.
5. Your product may appear different than the one illustrated. The installation procedures remain the same.
Please see next page for a larger installation image
TOOLS AND MATERIALS NEEDED
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put them onto a
clean and soft cloth to protect finish. Confirm all parts are included.
2. Turned off power at the circuit breaker or fuse box.
3. Attach mounting plate (B) onto outlet box with screws (D).
4. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture green or bare ground wire to the green or bare copper wire in
outlet box with wire nut (A) or fasten onto ground screw (C) on
mounting plate.
WARNING: Never fasten the ground wire to the black or white power
supplier wire, failure to follow this instruction could result in serious
injury or death!
5. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture Lead wire with ridge(s) or white wire to the white wire in outlet
box with wire nut (A). Wrap the wire connector with electrical tape, so
that the tape seals the end of fastener.
6. Fasten fixture Lead wire without ridge(s) or black wire to the black wire
in outlet box with wire nut (A). Wrap the wire connector with electrical
tape, so that the tape seals the end of fastener.
7. Press together the two connectors (E).
8. Tuck wires carefully inside outlet box. Attach the canopy (G) onto wall
then secure it with screws (F).
9. NOTICE: Do not exceed recommended wattage. Install lamp(s). Rated
Max 60 W, Type G/T/A/B. (Bulb(s) not included)
10. Install glass (I) onto glass holder with screws (H).
11. Restore power to circuit at breaker or fuse box.
CLEANING
Please clean fixture with a soft and dry cloth ONLY. Clean glass with a mild
soap.
Approved fastener
(Wire nut)
Electrical tape
Phillips &
Flathead
Screwdriver
Slip Joint
Pliers
Small
Adjustable
Wrench
Wire
Cutter/stripper
Electrical
Current
Tester
Electrical
Tape
Allen Wrench