began Bench top Dishwasher (8 place settings) KABNCTPDWSA Quick Start Guide Table of Contents Safety & Warnings. Overview... Quick Operation Guide.. Control Panel. Feature: Installation Cold Water Connection Drainage Hose.. Pr-Use Checklist. Operation... Rinse-Aid Dispense s b Cleaning & Ca Spray Troubleshooting.. safety & Warnings BB wwwemno: 1 1 Handle with care and Inspect regularly to ensure product Is In good working order.
Do not operate your dishwasher unless all enclosure panels are properly in place. Open the door very carefully if the dishwasher is operating, there is a risk of water squirting out. Do not place any heavy objects on or stand on the door when it is open. The appliance could tip forward.
Control Panel s 1. Power Button 6. Delay setting indications 2. Delay Set 7. Programmer Selector 3. Rinse Aid Warning Light (Indicates when the rinse-aid dispenser needs to be refilled) 8. Start/Pause 4. Programmer End Indicator 9. Programmer Indicator 5. Water Failure Indicator (check faucet) Features Front uni Baek:Viow 8 1. Detergent Dispenser |2. Filter Assembly 3. Rinse Aid Dispenser 4, Spray Arms 5. Cup Shelf 6. Basket 7. Inlet Pipe Connector 8.
Installation Post ion the appliance in the desired location. The back should rest against the wall behind it and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with a water supply and drain hoses that can be positioned to the left or right to facilitate installation. Cold Water Connection Connect the cold water supply hose to a threaded 3/4” connector and ensure that it is fastened tightly in place.
Before use, add rinse-aid and detergent. Rinse-Al Dispenser The rinse-aid is released during the final rinse to prevent water from forming droplets on dishes, which can leave spots and streaks. It also improves drying by allowing water to roll off the dishes. The dishwasher is designed to use liquid rinse-aids. The rinse-aid dispenser is located inside the door next to the detergent dispenser.
Loading and Usage Recommendations « Consider buying utensils which are identified as dishwasher-proof. « To prevent damage, do not take glass and cutlery out of the dishwasher immediately after the programmer has ended. * Scrape off any large amounts of leftover food. Soften remnants of burnt food in pans It is not necessary to rinse the dishes under running water. « Load hollow items such as glasses, pans, etc. upside down to avoid water collecting.
Wash Programmed wash Washtubs ©) g g Singe: For most washyeaisfantidishen Fighting 5200 55 tng 2 [t Brine pledge ! Drying Brainwashing i) 1 . Wash (600} For wash resistant dishes: Rinse By 150 108 d Haney: Rinse (85°CY Dinging Squash Standard programming.
Cleaning & Care General Maintenance . Door Clean with a soft, warm, damp cloth. Filter The filter assembly comprises the Main Filter (A), Fine Filter (B) and Coarse Filter (C). To disassemble: Step 1. Rotate filter assembly and raise it. Step 2: Lift B and C from A. Step 3: Filter is disassembled. Clean gently with a cleaning brush. Note: Follow steps in reverse to reassemble.
Spray Arms To remove the upper spray arm, hold the nut, rotate the arm clockwise to remove it. To remove the lower spray arm, pull out the spray arm upward. Wash the arms in soapy and warm water and use a soft brush to clean the jets. Replace them after rinsing thoroughly.
Knocking noise in water pipe | On-site installation or piping No affect on dishwasher function; cross-section contact plumber Dishes not clean Dishes not loaded correctly See notes on “Loading” in Operation Cleaning programmer insufficient | Set more powerful programmer Insufficient detergent Use more detergent or change detergent used Items blocking path of spray arms | Rearrange items or reduce load Filter in base of wash cabinet Clean/refit the filter combination unclean or incorrectly fitted Spray arm b