Skizze Pen User Manual P0101 KOGATOUCH CO.
1. Skizze Pen Driver Downloads ① Download from Microsoft Store ② Download from www.skizze.cn 2.Components Overview Please read the main components and their corresponding functions before using.
.Use a super-power pen ON/OFF SHORTCUT 1、Installation is successful, input user ID, pen tip verification is successful, Bluetooth is connected automatically, and pen is enabled. 2、Installation successful, input user ID, pen tip verification successful, confirm to enable pen 3、Click on the key, the pen tip indicator is white, and the pen enters the starting state. 4、The pen tip indicator is white, and the pen is connected with the touch device.
、Windows Ink writing Set up The function setting interface for shortcut key click and double click is as follows: Press the rubber key long enough to erase the handwriting. 5.
6、 Charging Blink in red Red on Green on Low Battery Charging Fully Charged 7、Replace Nib The nib is a consumable item, if the nib is worn during use, please replace it as shown above.
The package contains two spare nibs, if you want more extra, please purchase on authorized website. The smart pen contains precision components. Do not disassemble when replacing the pen nib. 8、Safety information Please read the safety precautions carefully before using this smart pen: △ ! Power cord security When charging, please put the smart pen in a proper position △ ! Do not try to repair Do not attempt to disassemble, repair, or change any part of the product to avoid risk to you.
PCB Accessory Pb Hg Cd Cr(VI) PBB PBDE : Indicates that the content of harmful substance in all homogeneous materials of the part is below the limit requirement specified in GB/T 26572. : Indicates that the content of the harmful substance in at least one of the homogeneous materials of the part exceeds the limit requirement specified in GB/T 26572-2011, but meet the environmental protection requirements of the EU RoHS Directive.
FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.