Expert Grip Unit LDT - Manual

ManualsBrandsKO Propo ManualsBoatsEX-NEXT LDT 2.4GHz Radio System w/KR-420XT Receiver (Short) (Lay Down Trigger)

Expert Grip Unit LDT

KONDO KAGAKU Co., Ltd.

www.kopropo.co.jp

Installation

*This example is using the EX-RR/EX-2.

Slide foot

Connecting the battery

First

Attach to the Master unit

Content of products :

LDT Grip Unit

Throttle lever(wide)

Trigger Pad Set for Throttle (Black)

Brake Spacer white(1mm)

black(2mm)

Tx battery box3(LDT)

Balance terminal extension cable

About this product

Remove terminal cover.

Attach to the Master unit

1. Open the battery cover on the bottom of the Unit.

2. Insert battery to the battery box, and connecting the connector.

In case of using dry battery

3. Insert the Battery box and the Battery cover back to the unit.

About trigger unit

Please insert batteries with notice of direction of +/ -

Please attach with noticing the direction of

the battery box.

Battery Box

Cable

AAA battery 4pcs(sold separately)

Install the battery side up so that

the battery is sideways.

Connector

Ver1.1Lay down trigger

https://www.kopropo.co.jp/en/support/view/266

Please turn off power to remove the unit and install.

Name of a each part

Forward

Reverse

Power switch

LDT Trigger Unit

(DETAIL: Setting of LDT trigger Unit)

ET 5

ET 4

Grip Pad (F)

Grip PAD

Slide footBattery Cover

Charging Connector

Cover

Grip Pad(B)

Slide foot

Trigger Base Throttle Lever

* Bottom View

Finger hold cover

Instruction Manual

Please pull this out when the transmitter can easily

topple over like when using the 3D extension.

This product has a newly designed trigger mechanical unit that has changed

from a normal trigger type grip unit. This product is a model that has

achieved an improved operational feeling.

Please refer to each transmitter manual for proper usage.

Please remove and attach this unit

after install the steering unit to master

unit, because the steering lock lever

interferes.

Please perform the Adjust VR function after installing

this unit.

1) Breakage of the part by assembly.

2) Damage judged to be based on the operation after assembling.

3) When reconstruction of this product and analysis are conducted.

Explanation of product warranties

Explanation of Licensing

Due to the nature of radio controlled models, improper handling

may lead to dangerous situations. Therefore please read the

following information carefully in order to ensure safe operation.

Please also understand that KO Propo is not responsible for any

injuries or damage which result from noncompliance of these

cautions and notices.

Improper handling/usage may lead to a high prob-

ability of material damage as well as a possibility of

serious personal injury or even

death.

Improper handling/usage may lead to personal

injury or material damage.

Warning

Caution

ForSafeOperation

Warning

Prohibited

matters

Warning

Enforcement

matters

WhenInstallingComponents

Warning

Prohibited

matters

Warning

Enforcement

matters

Caution

Prohibited

matters

NotesforUsage

Warning

Enforcement

matters

Caution

Enforcement

matters

NotesAfterUsage

Danger

Enforcement

matters

Danger

Prohibited

matters

TransmitterBatteryHandlingandCharging(separatelyavailableoption)

* If there is batter y f luid leakage, avoid contact with eyes as it may result in

blindness. If contact with eyes occur, flush with large amounts of water and seek

medicalattentionimmediately.

* When disposing batteries, Ni-Cd, Ni-MH, Li-Po, and Li-Fe batteries should be

recycledinordertohelpprotecttheenvironment.

Caution

Enforcement

matter s

KONDOKAGAKUCO.,LTD.

 Servicedepartment

ADDRESS : 4-17-7Higashi-Nippori,Arakawa-kuTokyo

Japan116-0014Japan

TEL : 03-3807-7648(service)

9:0 0 -12: 0 0 & 13 : 0 0 -17:0 0  M - Fexc e pt

na tio nalholidaysSa turdayandSunday

closed

Latestinformationcanbeaccessedhere.

>>http://www.kopropo.co.jp

Contac tinformationforrepairinggoods

•Make sure metal parts on the model (car chassis/ship hull) do not come into

contact with each other.

*Contact between metal parts may result in noise, which could cause the receiver

to malfunction and lead to an uncontrollable model.

•Do not cut or bundle the antenna cable.

*This may lower the receiver's sensitivity and lead to an uncontrollable model.

•Ensure correct polarity when installing transmitter an d re c e i ver batteries.

*Incorrect polarity may damage the product.

•Within Japan, this product is limited to usage with models which operateon

thegroundorinthewater.

*Donotuseforothernon-designatedpurposes.

•Ensure that all connectors (receiver, servo, switch, etc.) are connected securely.

*Ifconnectionsbecomelooseduetovibrations,itmayleadtoan

uncontrollablemodel.• Securely attach receiver with thick double-sided tape

and ensure that it does not make contact with other parts.

*Strong shocks or contact with other parts due to vibrations may lead toan

uncontrollablemodel.• C h e ck servo operation to ensure th e pushrod is not

subject to excessiveloads.* Excessive loads may damage the servo or

increase batter y power consumption.• Make sure to use the rubber grommet

when attaching the servo and thattheservodoesnotcontacttheR/C

equipmenttray.

*Ifvibrationsaffecttheservo,itmayleadtodamageoranuncontrol lable

model.

•Use in conjunction with genuine official KO Propo products.* KOPropoisnot

responsibleforanydamagesorinjurieswhichresult fromuseofthisproduct

incombinationwithothermanufacturer's products.

•Do not use when there is thunder.

*It is possible for lightning to strike the antenna.

•Do not use in the rain or in areas where water has accumulated.

*Ifwaterenterstheproductitmayleadtoanuncontrollablemodel.

•Do not use in the following locations:

1. Near R/C circuits (within 3km) 

2.Nearcrowds,onstreets,ornearactualvehiclesorships

3. Near high-voltage power lines or communication facilities.

*Ifsignalinterference,etc.causesanuncontrollablemodel,aseriousaccident

mayresult.

•Do not use when your concentration levels are compromised by tiredness,

alcohol,medication,etc.

*Mistakes in judgment may result in serious accidents.

•Do not allow g l ow engine fuel or engine exhaust to contact the product.

*These may attack the plastic and damage the product.

•Check to ensure that the selected model memory matches the model tobe

controlled.

*Using an incorrect memory may lead to an uncontrollable model.

•Make sure to stop the engine (disconnect motor cables) before changing

transmittersettings.

•Do not touch engine, motor, ESC, etc. immediately after use as they maybe

hot. *Doingsomayleadtoburns.

•When switching on, always turn on the transmitter first, followed by the

receiver. Follow the reverse order when switching off.

*Ifthewrongorderisfollowed,itmayleadtoanuncontrollablemodel.•

Dismantling or modifying the RF Module (internalized in the case of the

EX-RR) is prohibited and is punishable by law.

*DoingsomayleadtoaccidentssuchasshortcircuitsandKOPropo

Customer Service Department may not accept dismantled/modified

productsforrepair.

•Do not use this product in aircraft, hospitals, or near fire alarms or medical

equipment.

*This may lead to malfunctions and result in serious accidents. Also, by law

youmustceaseoperationiftheproductaffectsotherwirelessorelectrical

devices.

•2.4GHz transmitters must be registered with the Japan Radio Control Safety

Association.*Thetransmitterwhichyouhavepurchasesisalready

registered.Productswhichdonothaveproofofregistrationareillegal.

•In the case of an R/C car, make sure to remove the battery pack after driving.

*Ifthecarisswitchedonaccidentally,itmayleadtoafireoranuncontrollable

model.

• Keep transmitters, batteries, and models away from small children.

*Chemicalagentsandtheitemsthemselvesmaycausepersonalinjury.

•Remove batteries from transmitter if it will not be used for a consider-abletime.

*If batteries are left in the transmitter, battery leakage may result in damage.

• Do not store transmitter/receiver in the following conditions:

1. Extremely hot (over 40ºC) or cold (below 10ºC) temperatures.

2.Locationsindirectsunlight.

3. Locations with high humidity.

4. Locations subject to vibrations.5.Locationswithlotsofdust.

*Theseconditionsmaycausethecasetodeformanddamagetheproduct.

•Never short-circuit the battery connector.

*Thismayleadtoafireorexplosion.

•Do not dispose batteries in fires.

*Thisisverydangerousandmayleadtoanexplosion.

•Use KO Propo chargers to charge the battery and use the correct current

(under 1A).

*Incorrectcurrentmayleadtobatterydamage,overheating,orleakage.

*Othermanufacturer'schargersmaynothaveaautomaticcutofffunction.

•Do not subject the battery to strong shocks.

*This may damage the battery and cause leakage or a short circuit.

•Do not dismantle or modify the battery.

*This may cause dangerous leakage of battery fluids.

•Keep away from water. Do not charge a wet battery.

*Thismaycauseoverheatinganddamage.

•Do not charge alkaline batteries.

*Alkaline and other single-use batteries cannot be recharged. Doing so may

leadtofireanddamage.

•Do not use wet hands when plugging in the charger's AC Adapter.

*This may result in electrical shocks.

If this is being used with EX-2 (Xpansion Ver.1.07 or earlier), there

will be some problems when using the Throttle>ReturnSpeed

function. All other functions will operate correctly.

Please refer below support information at URL about Update file.

The company name or the brand name for each reference in the text is a

registered trademark.

Downloading the software from the attachment or from our homepage for

this product and being used for the sole purpose of this product is accepted.

Please do not use this for any other use.

This product, software and the intellectual property rights are the legal rights

of Kondo Kagaku Co.,ltd.

The act of which breaks the law, can result in penal regulations and other

applicable laws in the region that the violation takes place.

KondoKagaku co.,ltd. guarantee after-sale service and others about this

product. However, please understand that it cannot guarantee about the

following points on the character of this product.

for Brake (Gray)

Summary of content (2 pages)

PAGE 1
Slide foot •When switching on, always turn on the transmitter first, followed by the receiver. Follow the reverse order when switching off. *If the wrong order is followed, it may lead to an uncontrollable model.• Dismantling or modifying the RF Module (internalized in the case of the EX-RR) is prohibited and is punishable by law. *Doing so may lead to accidents such as short circuits and KO Propo Customer Service Department may not accept dismantled/modified products for repair.
PAGE 2
When using a battery that is for the transmitter. Please check the battery mode in the transmitter and choose correct battery. *Please refer manual for how to setting. 1, Open battery cover and connect the battery for the transmitter to the connector. Setting of Volume Information Adjustment of LDT Trigger Unit *This is an example using the EX-RR/EX-2. This function is for setting the steering and throttle position information to the transmitter (calibration). You must perform this setting.