User's Manual

ManualsBrandsKnox ManualsElectronicsRadio Module

P a g e 1 | 5

User’s Manual

CC3100MODR11MAMOB Module

Introduction

The CC3100MODR11MAMOB module allows for Wi-Fi 802.11b/g/n communications from the Knox System to

wireless networks to connect with the KnoxConnect™ system using a Laird CAF94505 antenna, Taoglas

FXP840.07.0055B, Air802 external antenna, or Larsen NM05E2400B It is built from a standard networking

component acquired from a large semiconductor supplier to ensure a long-lifetime secure supply in support

of Knox systems.

This CC3100MODR11MAMOB module is placed into the KeyDefender on whose labels state “This Device

Contains: FCC ID: 2AOVI-KNOX-RAS and IC: 23479-KNOXRAS”.

Use

The CC3100MODR11MAMOB can use either the Laird CAF94505 ,Taoglas FXP 840.07.0055B, Air802

ANRD2405-RPSMA, or Larson-NM05E2400B. The antennas have the following specifications:

Summary of content (5 pages)

PAGE 1
User’s Manual CC3100MODR11MAMOB Module 1. Introduction The CC3100MODR11MAMOB module allows for Wi-Fi 802.11b/g/n communications from the Knox System to wireless networks to connect with the KnoxConnect™ system using a Laird CAF94505 antenna, Taoglas FXP840.07.0055B, Air802 external antenna, or Larsen NM05E2400B It is built from a standard networking component acquired from a large semiconductor supplier to ensure a long-lifetime secure supply in support of Knox systems.
PAGE 2
The Air802 ANRD2405-RPSMA antenna has the following Specifications: Type External rubber ducky Gain 5 dBi Impedance 50 ohms The Larson NM05E2400B Antenna has the following specifications Type External Collinear Gain 5 dBi Impedance 50 ohms The module interfaces with the antenna’s reverse polarity SMA (RP-SMA) plug-male connector using a rightangle bulkhead connector on the Printed Circuit Board Assembly. NOTE:The CC3100MODR11MAMOB is certified to be used with any of the above listed antennas.
PAGE 3
RF Exposure statement This product has been evaluated for RF exposure and determined to meet applicable requirements via low power exemption. This module may be installed into products where antenna to user distance is greater than 20cm. Only the following antennas are approved to be used with this module: Laird CAF94505, Taoglas FXP840.07.
PAGE 4
The following warnings must also be placed in the User Manual of the finished product using this module: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 5
If the antenna used in the finished product is detachable or user serviceable then the following must be included: This radio transmitter IC: 23479-KNOXRAS has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.