Instruction Manual

EverSparkleTechnologiesLimited

ControllerInstructionManual

A. BelowistheControlbuttonlayoutdrawing



B. Howtooperatethebuttons

1. [Power/OK]button

i. Pressoncetopoweronthecontroller.Thedefaultsettingofturnofftimeis15minutes.Theunitwillbe

turnedoffaspertheTimersetting.

ii. Toturn

offthecontrollerwhentimerhasnotbeenreached,pressandholdthe[Power/OK]for3seconds.

iii. Use[Up] / [Down]buttonstoadjustthepowerlevel.Therearetotal5levelscanbeset.

Remark:Whenreachestolevel5andpressthe[Up]button,thelevel5LED

willbeflashedwith0.5sec

interval.Whenreach esto level1andpressthe[Down]button,thelevel1LEDwillbeflashedwith0.5sec

interval.

Whenthetemperaturehasbeenraisedtoacomfortab lelevel,pressthe[Power/OK]buttononcetofixthe

temperature.

Question:‐Howto

operateonApp?

iv. Thetemperaturesetbyaboveitem‘iv’willbereleasedwhen[Up]or[Down]buttonispressed.

v. Thetemperaturesetbyabovestep‘iv’willbestoredinthememory.Whentheunithasbeenpoweredon

againwithoutpressingthe[Up]/[Down]buttons,thesametemperature

settingwillbeapplied.

vi. Themaximintemperaturewillbesetat50degreesC.

vii. Tofurtherincreasethetemperaturetoabove50degrees,pressandholdthe[Up]buttonfor5seconds.

viii. Thetemperaturewillnotbeincreasewhenreaches60degreesC.



2. Downbutton

Each

pressonthebuttonwillreducethepowerbyonestep.



3. LevelIndicator(LEDs)

Toindicatethepowerlevel.



4. Upbutton

Eachpressonthebuttonwillincreasethepowerbyonestep.



5. Timerbutton

i. Defaultis15minuteswhenpoweron.

ii. Pressonceto

switchto30minutes.

iii. Pressonemoretimetoswitchto60minutes.

iv. WhenpressingtheTimerbuttoncontinuously,itwillbecycledbetween15minutesto60minutes.

End

PAGE 1
Ever Sparkle Technologies Limited Controller Instruction Manual A. Below is the Control button layout drawing B. How to operate the buttons 1. [Power/OK] button i. Press once to power on the controller. The default setting of turn off time is 15 minutes. The unit will be turned off as per the Timer setting. ii. To turn off the controller when timer has not been reached, press and hold the [Power/OK] for 3 seconds. iii. Use [Up] / [Down] buttons to adjust the power level.
PAGE 2
FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.