Installation Guide

IRON HOLDER
Installation Instructions
RN209EFS_B_IronHolder_0213
© 2013 Knape & Vogt Manufacturing Company. All rights reserved.
Iron Holder
Inspect all parts and read all instructions prior to beginning assembly and installation.
Parts Included
A. Iron Holder
B. End Fittings (4)
C. Mounting screws

• Phillips screwdriver
• Drill with 1/16” bit for pilot holes
(optional)
• Tape Measure
• Pencil

IB-H-C
Place end fittings on the
iron holder as shown.
Position the iron holder
on the inside of the
cabinet door and mark
the mounting holes. If
possible, mount the iron
holder so the screws will
be placed in the
doorframe and not in the
center panel of the door.
It is recommended to use
small pilot holes drilled
into the door to avoid
splitting the wood. Fasten
the bottom end fittings to
the door. Make sure the
mounting screws are
shorter than the
thickness of the door, to
prevent the screws from
going through the door
face.
Fasten the top end fittings to the door. The side fittings can adjust 5/8” to position
the screw holes on the door frame if necessary. Installation is complete.
A.
B.
step 1
step 2
C.
KNAPE & VOGT MANUFACTURING COMPANY
2700 Oak Industrial Drive NE • Grand Rapids, MI 49505
800.253.1561 • www.kv.com