User's Manual

ManualsBrandsKMW U.S.A. ManualsElectronics800 MHz iDEN RRH

iDEN 800MHz RRH User Guide

iDEN 800MHz RRH

User Guide

Written by

Reviewed by

Approved by

JINHEE LEE

KSHIN

MICHALE YOON

Summary of content (8 pages)

PAGE 1
iDEN 800MHz RRH User Guide iDEN 800MHz RRH User Guide Written by Reviewed by Approved by JINHEE LEE KSHIN MICHALE YOON 1
PAGE 2
iDEN 800MHz RRH User Guide Index Contents 1. FCC Information ………………………………….….……..3 2. Test Environment ………………………………..………..3 2.1. Preperation List …………………………………..……..3 2.2. Testing Environement Configuration …………..……..3 2.3. RRH Setup Procedure …………………………..……….4 3. Network Configuration ………………………...………….5 4.
PAGE 3
iDEN 800MHz RRH User Guide 1. FCC Information RF Exposure compliance must be addressed at the time of licensing 2. Test Environment 2.1. Preperation List  iDEN 800Mhz RRH (Remote Radio Head 800MHz)  PSU (Power Supply Unit)  BBU (Base Band Unit, Alacaltel Lucent)  Optic transceiver 2EA (Yellow- 1550nm, Blue- 1310nm)  Optic Cable  RJ45 Ehternet Cable  Laptop computer for RRH GUI 2.2.
PAGE 4
iDEN 800MHz RRH User Guide  PSU Setting Table Voltage Low : -38V Normal : -48V High : -57V Current Limit 12 A 9.5 A 8A 2.3. RRH Setup Procedure  Checke PSU Power 48V off  Connect PSU power to RRH Power connector  Connect BBU and RRH with Optic transceiver and Optic cable RRH side; Blue Transceiver (1310nm) BBU side; Yellow Transceiver (1550nm)  Turn on PSU to power up RRH  Make sure computer to join RRH and BBU network.
PAGE 5
iDEN 800MHz RRH User Guide 3. Network Configuration  Setup computer network configuration IP: assigned by ALU (ex; 10.10.10.55) Subnet mask: 255.0.0.0 Default gateway: assigned by ALU (ex; 10.10.10.1) DNS: assigned by ALU  Test network configuration Windows Start > Run > CMD [Enter] C:\> ping RRH IP(10.14.0.
PAGE 6
iDEN 800MHz RRH User Guide 4. Operate GUI Program  Run GUI Program. Input RRH’s IP and click the Connect button  Setup the carrier configuration on the index to turn on carrier power. If you want to make LTE single carrier configuration, please follow below setting and click (A) SET button. Ex) 1FA setup with LTE signam on Index 3 (Tx; 865.4MHz, Rx; 820.
PAGE 7
iDEN 800MHz RRH User Guide  Change TXENABLE[v] from DISABLE to ENABLE and click (B)SET button to turn on RF Power 7
PAGE 8
iDEN 800MHz RRH User Guide  If you set up Signal Analyzer, you can monitor carrier power just like below image.