User's Manual

Klover MiK 16 Assembly Sequence

Klover Products Inc.

5807 W Fenrick Rd, Janesville, WI 53548

(888) 299-9009 - support @KloverProducts.com

Step 1 - Install horizontal cross bar on the top two connectors with the remaining connector pointing

toward the bottom of the dish

Step 2 - Install vertical handle and snap onto the horizontal cross bar

Step 3 - Focus microphone - Option #1 - Use the heavy black line printed on the label (located next to

the handle) to position mic 1 1/8” behind the rear

face of the mic yoke.

The feet at the bottom of the dish are also 1 1/8”

wide and can be used to locate the microphone with

respect to the mic yoke.

(Steps 4 and 5 are on the back of the sheet)

PAGE 1
Klover MiK 16 Assembly Sequence Step 1 - Install horizontal cross bar on the top two connectors with the remaining connector pointing toward the bottom of the dish Step 2 - Install vertical handle and snap onto the horizontal cross bar Step 3 - Focus microphone - Option #1 - Use the heavy black line printed on the label (located next to the handle) to position mic 1 1/8” behind the rear face of the mic yoke.
PAGE 2
Step 4 - Install Mic Yoke The thumb screw should be on bottom, small targeting screws on top, and arrows in both end plates pointing up. Remove second end plate from the microphone yoke, slide the first end plate onto locator pins, then place second end plate onto locator pins on opposite side of dish and snap into place. (If the end plates have been removed you may have to switch the two end plates in order to properly align them. There are small flats on the connectors that should match.