Owners Manual

INSTALLATION

Make sure that grille is removed from the speaker. Loosen all 4 of the screws

by turning them counter-clockwise until the clamps, or “dog ears” move

freely. DO NOT remove the screws.

Connect the wires using the spring clips by pushing down on the clip and

inserting the trimmed, exposed wire into the clip hole. Remove pressure on

the clip, and the wire should be locked into place. Remember, red clip is +

and black clip is - .

Note: For new construction, it is recommended that install Kit WK-8600 is

used for M-8600-W, M-8650-W, and M-8652-C.

Place the speaker into the hole and press tightly against drywall with one

hand, and tighten each of the screws until the speaker is firmly in place. Before

placing grille on speaker, make sure there are no vibrations when playing. If so,

check the installation screws to see if they need further tightening.

MAINTENANCE

These speakers require little maintenance and, if cleaning is needed, you

may use a dry cloth. If the speaker is subject to smoke or grease, a mild

detergent and moistened cloth may be used. DO NOT use harsh chemicals

or abrasives.

SPEAKER PLACEMENT AND LOCATION

Optimum speaker placement depends on personal listening preference

and, when used in home theater applications, follow standard listening

recommendations for left, center, right and surround usage (see below).

Make sure the speaker cutout is placed between two joists with plenty of

clearance. Use a stud finder to locate joists, and mark locations. Be sure

to avoid electrical wires and plumbing when cutting hole for installation.

If you encounter electrical wiring or plumbing, you may have to consider

another location.

PAINTING THE SPEAKER GRILLE

This speaker grille may be painted. To apply spray paint to the grille, follow

the manufacturer’s instructions and remember to remove the scrim before

finishing. To paint the outer bezel on press fit speaker chassis, use the

cutout template as mask, and paint.

AMPLIFIER

SPEAKER

PAGE 1
SPEAKER PLACEMENT AND LOCATION INSTALLATION Optimum speaker placement depends on personal listening preference and, when used in home theater applications, follow standard listening recommendations for left, center, right and surround usage (see below). Make sure that grille is removed from the speaker. Loosen all 4 of the screws by turning them counter-clockwise until the clamps, or “dog ears” move freely. DO NOT remove the screws.
PAGE 2
LIMITED LIFETIME WARRANTY This warranty is non-transferable, and only applies to the individual that made the original purchase. For warranty/service issues, please contact your place of purchase. Please hold on to your original receipt. The warranty covers any production and material defects of purchased product. The following is NOT COVERED by the warranty: 1. Accidents, misuse, poor maintenance, electrical overloads such as lightning or voltage. 2. No DIY, must be installed by CEDIA-qualified installer.