Installation Instructions Laundry Center Washer Dryer 240 Volt l
Check code requirements, some codes do not permit or llmlt mstallatlon of clothes dryers ln garages, Closets. mobile homes and sleeping quarters. Contact your local bulldIng Inspector. Hot and cold water faucets: must be wlthin 4 feet of the back of the washer/dryer and provide water pressure 5-100 PSI. Before you Check locatlon where washer/dryer WIII be mstalled Proper mstallatlon Is your responsibility.
Exhaust requirements 1 Four Inch Metal Exhaust Duct IS .equlred. (Do nol use 3 in exhaust duct.) Metal flex~ nay be used. Non-meta duct IS not recommende Use Duct Tape to peal all joints. Exhausting the dryer outside is recommende II dryer cannot be exhaus sutside, use Exhaust Defl Kit LCK4500 available from your KitchenAId dealer. Exhausting the dryer through the side of the washer/dryer requires use of Side Exhaust Kit LCK4600. Follow installation mstructions with the kit for proper exhaust mslallation.
Remove the 2 rear corner pieces attached to the back of washer/ dryer: Do not remove the foam shipping pieces between the washer and dryer until unit is in place. 11. Shlpplng Strap with key. Remove label. Take hoses out of basket. 1 Place hoses with other parts. NOTE: Use one hand to hold down agltator when removing shipplng straps. After straps ara removed release agitator, it will move upward. 10. Move foam shipping pieces outward iust enouah to clear the washer lb. Open iasher lid.
Use new hoses and washers that came with your KitchenAid washer/dryer. 13 washer coupling m Insert a flat washer Into each end of the lnlel hoses. Check lhal washers are firmly sealed in couplings. \ connector. Use pliers lo open clamp and slide clamp over drain hose. Check for good fll. 16 I dlsconnecL Remove clamp and coupling. Estimate length of dram hose needed. Cut flexible end of hose. (Do not cut hookshaped end of drain hose.) Push and twlsl couplmg securely onto drain hose.
love washerldryer to its ermanent location. Check levelness of n washer/dryer by Ilacing a carpenter’s level on top of dasher, first side to side then front I back. If it is not level, screw the ‘ant legs up or down to adjust. Tilt rasher forward raising back legs 1” IH of floor to adjust rear self:veling legs. Gently lower washer 3 floor. Make final check with level. 24. Check that you have all of your tools 30. 22 n ‘ut “hook” end of drain hose in tub jr standpipe.
Alternate exhaust methods To remove the power The washer/dryer mstallad in a mobile home must be exhausted JutsIde. When the dryer IS exhausted through the floor, the :xhaust system must termmate Jutside the enclosed area under noblIe home. Extension beyond the enclosure will prevent lint and noisture buildup under the mobile Tome. See Figure 3. 1, Remove the terminal block cover from the dryer. 2. Disconnect the power supply cord from the termmal block. 3.
When localcodes... When local codes... B.
- This appliance is manufactured with the neutral terminal connected to the frame. Replace lermitw Mock cover.
Recessedarea hlstructions This washer/dryer may be installed in a recessed area or closet. This installation spacing is in inches and is minimum allowable. Additional spacing should be considered for ease of installation and servicing. If closet door is installed the minimum air openings in top and bottom is required. Louvered doors with equivalent air openings are acceptable. Other installations must use the minimum dimensions indicated.