Installation Instructions

FILLER STRIP INSTALLATION INSTRUCTIONS

for Slide-In Ranges

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools Needed

■ #2 Phillips or #2 square tip screwdriver

■ Measuring tape

■ Electric drill

■ ¹⁄₈" (3 mm) drill bit

■ Pliers

■ Marker or pencil

Parts Supplied

■ Filler strip

■ 2 Mounting brackets

■ 4 #8–18 x ¹⁄₂" screws

NOTE: This filler strip is used only when the opening depth for the

slide-in range is deeper than the recommended opening depth.

Install Filler Strip

1. The filler strip can be used to fill gaps of 2⁵⁄₈" (67 mm),

2¹⁄₄"(57mm), or 1¹⁄₂" (38 mm).

It is recommended to mount the filler strip flush to the

countertop but it is not necessary.

2. Determine the approximate gap between the back of the

countertop cutout and slide-in range by measuring the

distance from the back of the countertop cutout to the front of

the countertop and subtracting 22³⁄₄" (57.8 cm) from the total.

3. Rotate the filler strip to determine the filler strip depth that

best fills the gap.

4. Align the filler strip edge to the back of the countertop cutout

and the countertop cutout sides. To keep the filler strip

straight, check that the back edge of the filler strip is flush to

the back wall of the countertop cutout.

A. 2⁵⁄₈" (67 mm)

B. 2¹⁄₄" (57 mm)

C. 1¹⁄₂" (38 mm)

A. Filler strip

B. Countertop

C. Countertop cutout

W10114233

PAGE 1
FILLER STRIP INSTALLATION INSTRUCTIONS for Slide-In Ranges Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
PAGE 2
5. Place the mounting brackets on each corner of the bottom side of the selected filler strip depth. Use a pair of pliers to fold the lower end tab of the bracket at the notch so that the tab acts as a support for the bottom edge of the filler strip. For 2¹⁄₄" (57 mm) and 2⁵⁄₈" (67 mm) depths, the bracket end tab should be folded at a 90° angle. For 1¹⁄₂" (38 mm) depth, the bracket end tab should be folded at a 45° angle.
PAGE 3
INSTRUCTIONS D’INSTALLATION PLANCHETTE DE REMPLISSAGE pour cuisinière encastrée Outillage et pièces Rassembler les outils et pièces nécessaires avant de commencer l’installation. Lire et suivre les instructions fournies avec les outils indiqués ici.
PAGE 4
5. Placer une bride de montage à chaque extrémité de la planchette de remplissage, sur la face inférieure (selon l'orientation d'installation choisie). Utiliser une pince pour plier la patte inférieure de chaque bride au niveau de l'encoche (la patte doit tenir lieu de support pour la face inférieure de la planchette de remplissage). En présence d'un espace à obturer de 2¹⁄₄" (57 mm) ou 2⁵⁄₈" (67 mm), on doit plier la patte de la bride à un angle de 90°.