Performance Data Sheet

W11407771C
Ice Maker Water Filtration System Model P6WG2KL
Replacement Filter Model ICE2, F2WC9I1, W10565350 Capacity 2000 Gallons (7571 Liters)
System tested and certified by NSF International against NSF/ANSI Standard 42 for
the reduction of Chlorine Taste and Odor.
This system has been tested according to NSF/ANSI Standards 42 for the reduction of the substances listed below. The concentration of the
indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the
system, as specified in NSF/ANSI Standards 42.
Replacement
Filter
Substance
Reduction
Aesthetic
Effects
NSF Reduction
Requirements
Average
Influent
Influent
Challenge
Concentration
Maximum
Effluent
Average
Effluent
Minimum %
Reduction
Average %
Reduction
Chlorine Taste/
Odor
50% reduction
1.9727 mg/L 2.0 mg/L ± 10% 0.71 mg/L 0.7788 mg/L
70.2 72.81
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.50 gpm (1.89 Lpm). Pressure = 60 psig (413.7 kPa).
Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 2000 gallons (7571 liters).
� It is essential that operational, maintenance, and filter replacement
requirements be carried out for the product to perform as
advertised. Property damage can occur if all instructions are not
followed.
� Use replacement filter F2WC9I1, W10565350 Part Number ICE2.
� NOTE: Flush 4 gallons (15.142 liters) of water through water filter
cartridge before use.
Style 1– When the water filter status display changes from “GOOD”
to “ORDER,” order a new filter. When the filter indicator reads
“REPLACE,” it is recommended that you replace the filter after 9
months.
Style 2– Press FILTER to check the status of your water filter. If the
filter indicator light is yellow and the words “ORDER FILTER” appear
on the display screen, order a new filter. If the filter indicator light is
red, it is recommended that you replace the filter after 9 months.
� These contaminants are not necessarily in your water supply. While
testing was performed under standard laboratory conditions, actual
performance may vary.
� The product is for cold water use only.
� Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the
system.
� For parts and service availability and installation, operation, and
maintenance instruction please refer to the Owners Manual.
� Refer to the “Warranty” section for the Manufacturer’s name,
address and telephone number.
� Refer to the “Warranty” section for the Manufacturer’s limited
warranty.
Application Guidelines/Water Supply Parameters
Water Supply Potable City or Well
Water Pressure
30 psi - 120 psi (207 kPa - 827 kPa)
Water Temperature
33°F - 100°F (0.6°C - 37.8°C)
Service Flow Rate 0.50 gpm (1.89 Lpm.) @ 60 psi
� Your water filtration system will withstand up to 120 pounds per
square inch (psi) water pressure. If your water supply is higher than
80 psi, install a pressure reducing valve before installing the water
filtration system.
Whirlpool Corporation
2000 North M-63
Benton Harbor, MI, 49022
[phone]
®
NSF is a registered trademark of NSF International.
PERFORMANCE DATA SHEET