KitchenAid _ INTEGRATED COMPACTOR For questions about features, operation/performance, In Canada, for assistance, parts, accessories or service, call: 1-800-422-1230 www, kitehenaid,eom installation or service, call: 1-800-807-6777 or visit our website at www, KitehenAid,ea Table of Contents ............................................................................................................
TABLE OF CONTENTS COMPACTOR SAFETY .................................................................. INSTALLATION INSTRUCTIONS .................................................. Unpacking .................................................................................... Location Requirements ................................................................ Electrical Requirements ............................................................... Undercounter Installation......................................
IMPORTANT SAFETY INSTRUCTIONS WAR N IN G-" When using an electrical m Read all instructions appliance, basic precautions before using the compactor. m Close supervision is necessary when used by or near children. Do not allow to be used as a toy, or to run unattended at any time. Lock Key Switch when not in use and store key out of reach of children. m Do not touch moving parts. m Do not operate with a damaged cord set, plug, motor, or after damage in any manner.
13. Remove the shipping base from the bottom of the compactor. A_ Clearance Dimensions I1 =ol B A. Leveling legs B. Shipping base Locat Product on Requ rements Dimensions I B_ i A. Leave 6" (15.2 cm) of clearance space to the right side of the compactor in order to remove the compactor bags. B. Leave 23" (58.4 cm) of clearance in front of the compactor in order to fully open or remove the compactor drawer. Electr cal Requ rements 341/8" (86.7 cm) _ 24" 15" (38.
Undercounter NOTE: Proper installation is your responsibility. Make sure you have everything necessary for correct installation. It is the personal responsibility and obligation of the customer to contact a qualified installer to assure that electrical installation meets all National and Local codes and ordinances. Tools Needed Gather the required tools and parts before starting installation.
Installation 1. Remove the 2 rubber bumpers from the lower corners of the inside drawer front. Set aside the bumpers and discard the screws. Cabinet-face Mounting A 2. NOTE: The bottom of the custom panel should not extend below the bottom rest tab at the lower center of the exterior drawer front. D 3. A. Mounting B. Cabinet 8. clip Grasp sides of the compactor of the drawer into the tracks. C. Retaining bracket D. Mounting screw drawer and place the bottom 9.
COMPACTOR USE 2, How Your Compactor Works The compacting ram is the part of the compactor which compresses the trash. The compacting ram does not go to the bottom of the drawer. You will not see compacting of trash the first few times you load the compactor. NOTE: The compactor drawer should be more than 1/2full before the compactor can begin to compress the load. Place trash in compactor. • Wrap or cover wet or messy trash.
Using the Air Flter 1. or Freshener Set the Air Filter switch to ON. The fan creates air movement in the compactor for odor removal. NOTE: The charcoal Air Flter works only when the Key-Knob is in the ON position. IMPORTANT: fan. 2. The air freshener will work with or without the Install ng a New Bag Do not use any kind of bag other than those designed especially for use in your compactor.
COMPACTOR Your new compactor is designed to give you many years of dependable service. However, there are a few things you are expected to do in order to properly maintain your compactor. This section will tell you how to clean and care for your compactor. Changing the Air Flter or Freshener CARE Cleaning Inside the Drawer NOTE: You may want to wear gloves since there may be bits of glass in the drawer. 1. Remove the bag. See "Removing a Filled Bag." 2.
Grasp the drawer on the sides and pull it out the rest of the way. Set the drawer down gently. 3= Cleaning the Ram NOTE: You may want to wear gloves since there may be bits of glass on the ram cover. 1. Wipe glass particles off of the ram cover with a cloth or paper towels. 2. Remove foods with a clean sponge or soft cloth and a mild detergent in warm water. Rinse and dry thoroughly with a soft cloth. Vacuum the inside of the cabinet.
ASSISTANCE Before calling for assistance or service, please check "Troubleshooting." It may save you the cost of a service call. If you still need help, follow the instructions below. When calling, please know the purchase date and the complete model and serial number of your appliance. This information will help us to better respond to your request. OR SERVICE If you need replacement parts If you need to order replacement parts, we recommend that you use only factory specified parts.
KITCHENAID ®COMPACTOR WARRANTY ONE YEAR LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, KitchenAid or KitchenAid Canada (hereafter "KitchenAid") will pay for factory specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a KitchenAid designated service company.
