KRSC 9011/1 KRSF 9005/SL KRSF 9005/BL KRSM 9005/A+ KRSC 9005/A+ Instructions for use
Before using the appliance 4 Safeguarding the environment 4 Precautions and general recommendations 6 If the appliance is not going to be used 7 Maintenance and cleaning 8 Storing, freezing and thawing food 9 Description of the appliance 10 “MULTIFLOW” air distribution 11 Guide to the inside parts 11 Using the appliance 12 ECO mode 15 Using the ice and water dispenser 15 Using the automatic ice-maker 16 Changing a water filter cartridge 17 Troubleshooting guide 18 After-sales S
Before using the appliance • Your new appliance is designed exclusively for domestic use. To ensure best use of your appliance, carefully read the operating instructions which contain a description of the product and useful advice. Keep these instructions for future reference. 1. After unpacking the appliance, make sure it is not damaged and that the door closes properly. Any damage must be reported to the dealer within 24 hours of delivery of the appliance. 2.
Safeguarding the environment Declaration of conformity • This appliance has been designed for preserving food and is manufactured in compliance with Regulation (CE) No. 1935/2004. • This appliance has been designed, manufactured and marketed in compliance with: - safety objectives of the “Low Voltage" Directive 2006/95/CE (which replaces 73/23/CEE and subsequent amendments); - the protection requirements of Directive “EMC" 89/336/EEC amended by Directive 93/68/EEC.
Precautions and general recommendations INSTALLATION • The appliance must be handled and installed by two or more persons. • Be careful not to damage the floors (e.g. parquet) when moving the appliance. • During installation, make sure the appliance does not damage the power cable. • Make sure the appliance is not near a heat source. • To guarantee adequate ventilation, leave a space on both sides and above the appliance and follow the installation instructions.
If the appliance is not going to be used In case of power failures of up to 24 hours Keep the doors of the appliance closed. In this way the stored food will stay cold as long as possible. For further information see chapter “Using the appliance”, section “Black-out alarm”. If the appliance is not going to be used - Disconnect the appliance from the power supply. - Remove all the food if you are going away for more than three weeks. - If the appliance has an automatic ice-maker: 1.
Maintenance and cleaning • Before any cleaning or maintenance operation, always disconnect the appliance from the power supply. • Periodically clean the appliance with a cloth and a solution of lukewarm water and neutral detergent specific for refrigerator interiors. • Never use detergents or abrasives. Never clean the refrigerator parts with flammable liquids. The fumes can cause fires or explosions. • Clean the outside of the appliance and the door seals with a damp cloth and dry with a soft cloth.
Storing, freezing and thawing food INTRODUCTION Wrap food so that no water, moisture or condensate can enter; this will prevent odours or aromas going from one part to another in the refrigerator, ensuring better preservation of frozen foods. Use plastic containers with hermetic lids, aluminium trays, aluminium foil, plastic film and waterproof plastic wraps. NOTE: Never place hot food in the freezer. Allow hot foods to cool to room temperature for 30 minutes, then wrap and freeze.
Description of the appliance ڹ 훽 훿 훾 REFRIGERATOR COMPARTMENT A. Inside light B. Inside light C. Adjustable shelf D. Shelf - drawer lid E. Snacks drawer F. Crisper G. Crisper adjustment H. Meat / vegetable drawer I. Meat / vegetable drawer adjustment J. Bottle rack K. Dairy products compartment L. 2-litre door tray with bottle holder M. Door trays N. 0.75 litre door tray O. Water filter P. “Multiflow” (depending on model) FREEZER COMPARTMENT Q.
“MULTIFLOW” air distribution “MULTIFLOW” is a ventilated air distribution system, which ensures a homogeneous temperature inside the refrigerator compartment. Thanks to this system, the different types of food can be stored on any of the shelves of the appliance. Attention should be paid not to obstruct the air distribution vents, thus ensuring free air circulation. Guide to the inside parts Removing and repositioning the refrigerator compartment and freezer shelves.
Using the appliance FIRST USE Freezer temperature The factory-set ideal temperature is -18°C. As soon as the freezer compartment reaches the required temperature, it is automatically displayed. To change the temperature press the freezer temp button until the desired value is reached. The selected temperature will start flashing and then come on permanently, within 5 seconds, on the display. Connect the appliance to the water system and power supply (refer to the Installation manual).
Using the appliance ALARMS Water filter This symbol indicates the state of the water filter. When switching on the appliance for first use, or after replacing the filter, the filter icon shows three dashes. In time their number will decrease, depending on the use of the appliance and the natural wear of the filter charge itself. When all the dashes disappear and the icon starts flashing, the filter needs replacing.
Using the appliance Fast freezing (freezer) This function must be activated before freezing fresh food. To activate the function press the menu button until the fast freezing symbol appears on the left of the display. The symbol starts flashing and the freezer door icon comes on. Press OK to confirm. The function will automatically deactivate after 24 hours. It can also be deactivated manually at any time by repeating the procedure.
ECO mode This optional function can be used to save energy. Note: It is important to remember that this function does not disconnect the appliance from the power supply. To activate it press the “Fridge temp” and then the OK key. Keep both keys pressed for approximately 5 seconds until the display goes off completely.
Using the automatic ice-maker After switching on the refrigerator, it usually takes overnight for the first ice cubes to form. When selecting crushed ice, the cubes are crushed just before being dispensed, therefore the crushed ice may come out with a slight delay. Noise from the ice crusher is normal, and pieces of ice may vary in size. When changing from crushed ice to ice cubes, a small amount of crushed ice may come out together with the first cubes.
Changing a water filter cartridge 1. Locate the water filter cartridge cap below the freezer compartment door. Rotate the cap counterclockwise to a vertical position and pull the cap and filter cartridge out through the base grille. Note: Since there is water in the cartridge, some spilling may occur. 2. Remove the cartridge cap by sliding it off the end of the old cartridge. DO NOT DISCARD THE CAP. 1 3. Take the new cartridge out of its packaging and remove the protective cover. 4.
Troubleshooting guide Before contacting the After-sales Service… Operation problems are often due to minor causes that can be found and fixed without using any tools. Noises from the appliance are normal, since the fans and compressors for controlling its operation switch on and off automatically.
Troubleshooting guide The appliance does not work: • Is the power cable plugged into a socket powered with the right voltage? • Have you checked the protection devices and fuses of your home’s electrical system? The motor seems to run too much: • Is the condenser free of dust and fluff? • Are the doors properly closed? • Are the door seals intact? • On hot days or when the room is warm, it is normal for the motor to run longer.
Troubleshooting guide If the dispenser does not work: • Is the freezer compartment door closed? • Is the ice bucket correctly installed? If the ice dispenser stops working: • Are the ice cubes stuck because the ice dispenser has not been used for some time? Shake the ice bucket to separate the cubes and increase the holding capacity. It is advisable to throw away the old ice cubes and make new ice.
After-sales Service Before contacting the After-sales Service: Switch the appliance on again to see if the problem has been solved. If it has not, switch off the appliance again and repeat the operation after one hour.
Printed in Italy 03/08 5019 715 02027 n GB