Dimension Guide

PRODUCT MODEL NUMBERS
Because Whirlpool Corporation includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10888963A
07/27/2016
KMBP107EKMBP100E
27" (68.6 cm) and 30" (76.2 cm) Electric Built-In
Convection Microwave Oven
PRODUCT DIMENSIONS
27" (68.6 cm) and 30" (76.2 cm) Microwave Ovens
B
E
C
D
A
27" (68.6 cm) models
A. 25
3
/
8
" (64.5 cm)
B. 18
5
/
8
" (47.3 cm) overall height
C. 26
3
/
4
" (68.0 cm) overall width
D. 21
1
/
2
" (54.6 cm)
E. 17
3
/
8
" (44.1 cm)
30" (76.2 cm) models
A. 28
3
/
8
" (72.1 cm)
B. 18
5
/
8
" (47.3 cm) overall height
C. 29
3
/
4
" (75.6 cm) overall width
D. 21
1
/
2
" (54.6 cm)
E. 17
3
/
8
" (44.1 cm)
MINIMUM INSTALLATION CLEARANCES
For proper installation, the following minimum clearances must exist
above and below the cabinet opening.
Installation Above Single Built-In Oven
1"
(2.5 cm)
1"
(2.5 cm)
from top
of oven
A
B
A. Upper cabinet
B. Lower single oven
Approved models: KMBP100E and KMBP107E
NOTE: The microwave oven spacer kit will allow the microwave oven to be
installed in a 17
3
/
8
" to 17
3
/
4
" (44.1 cm to 45.1 cm) maximum cutout height.
A microwave oven spacer kit is available from your dealer that will allow
the microwave oven to be installed in a 19
1
/
4
" to 19
11
/
16
" (48.9 cm to
50.0 cm) maximum cutout height. Match the oven size to the following kits:
■ 27" (68.6 cm) Stainless steel - Spacer Kit W10469901
■ 30" (76.2 cm) Stainless steel - Spacer Kit W10469903
■ 27" (68.6 cm) Black stainless steel - Spacer Kit W10842586
■ 30" (76.2 cm) Black stainless steel - Spacer Kit W10842584
To order, see the “Assistance or Service” section of the Use and Care
Guide.
27" (68.6 cm) models
A. 26
3
/
4
" (67.9 cm) overall width
30" (76.2 cm) models
A. 29
3
/
4
" (75.6 cm) overall width
27" (68.6 cm) and 30" (76.2 cm) Microwave Oven Spacer Kit
A
CABINET DIMENSIONS
27" (68.6 cm) and 30" (76.2 cm) Microwave Ovens
A
B
C
D
E
F
G
27" (68.6 cm) models
A. 27" (68.6 cm) min. cabinet
width
B. 18
5
/
8
" (47.3 cm) from bottom
of cutout to bottom of upper
cabinet door
C. 40" (101.6 cm) bottom of
cutout to floor (recommended)
D. 25
1
/
2
" (64.8 cm) cutout width
E. 1
1
/
2
" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 17
5
/
8
" (44.7 cm) recommended
cutout height (will fit cutout
height from 17
3
/
8
" [44.1 cm] to
17
3
/
4
" [45.1 cm])
G. 21
7
/
8
" (55.5 cm) min. cutout
depth
30" (76.2 cm) models
A. 30" (76.2 cm) min. cabinet
width
B. 18
5
/
8
" (47.3 cm) from bottom
of cutout to bottom of upper
cabinet door
C. 40" (101.6 cm) bottom of
cutout to floor (recommended)
D. 28
1
/
2
" (72.4 cm) cutout width
E. 1
1
/
2
" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 17
5
/
8
" (44.7 cm) recommended
cutout height (will fit cutout
height from 17
2
/
8
" [44.1 cm] to
17
3
/
4
" [45.1 cm])
G. 21
7
/
8
" (55.5 cm) min. cutout
depth
ELECTRICAL CONNECTION
To properly install your microwave oven, you must determine the type
of electrical connection you will be using and follow the instructions
provided for it here.
■ Microwave oven must be connected to the proper electrical voltage
and frequency as specified on the model/serial/rating plate. The
model/serial/rating plate is located underneath the control panel along
the oven vent.
■ The microwave oven rated 120-/240-volt, 20-amp, has 4 wires (L1, L2,
N, and G) in the flex conduit and should be connected to a 20-amp
maximum-rated circuit, overcurrent protected on both the L1 and L2
circuits.
■ A time-delay fuse or circuit breaker is recommended.
A
A. Model/serial/rating plate