Instructions for use
Installation diagrams 4 Important safety information 6 Safeguarding the environment 7 Declaration of conformity 7 Before use 8 Using existing pots and pans 8 Recommended pan base diameters 8 Installation 8 Electrical connection 9 Instructions for use 10 Cleaning 14 Troubleshooting guide 14 After-Sales Service 15
Installation diagrams MODEL KHDD 3040/3050 210 mm 240 mm 145 mm 297 94 15 4 5 60 6 57 32 8 30 1 R 10 33 min50 0 +01 +10 7 60 m 100 in 30 7 4 58 2 45 4 11
Installation diagrams q w e r t 5
Important safety information YOUR SAFETY AND THE SAFETY OF OTHERS ARE VERY IMPORTANT - The appliance is designed solely for household use for cooking food. No other type of use is allowed (e.g. heating the room). The Manufacturer declines all responsibility for inappropriate use or incorrect setting of the controls.
Safeguarding the environment Disposal of packaging materials The packaging material is entirely recyclable and marked with the recycling symbol ( ). Do not dispose of the various packaging materials carelessly, but do so responsibly and in full compliance with local authority regulations governing waste disposal. Energy saving For optimum results, observe the following advice: • Use pots and pans whose bottom diameter is equal to that of the cooking zone. • Only use flat-bottomed pots and pans.
Before use IMPORTANT: the cooking zones will not switch on if pots and pans are not of the correct dimensions. Only use pots bearing the symbol "INDUCTION SYSTEM" (See figure opposite). Before switching the hob on, position the pot on the desired cooking zone. Using existing pots and pans Use a magnet to check whether pots or pans are suitable for use on the induction hob: pots are unsuitable if they cannot be magnetically detected.
Electrical connection WARNING - Disconnect the appliance from the mains power supply. - Installation must be carried out by a qualified electrician who is fully aware of current safety and installation regulations. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations provided in this chapter. The power supply cable must be long enough to allow the hob to be removed from the worktop.
Instructions for use Control Panel Description The control panel is equipped with touch controls: to use them, just press the corresponding symbol (a light touch is sufficient). KHDD 3050 KHDD 3040 Switching the hob ON/OFF To switch the hob on, press and hold down the key for about 2 seconds: the luminous indicator lights up. To switch off, press the same key until the hob switches off. All the cooking zones are deactivated.
Instructions for use "BOOSTER" function has a max. duration of 10 minutes, after which the appliance automatically goes to level 9. Deactivating cooking zones Select the cooking zone to be switched off by pressing the + / - key (a dot at the bottom right of the power level appears).Press "-" until bringing the power level to "0" or press the "+" and "-" buttons together. The cooking zone is deactivated and, if the area is hot, the letter "H" appears. "H" is the residual heat indicator.
Cleaning WARNING - Never use steam cleaners. - Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator ("H") is not displayed. IMPORTANT: do not use abrasive sponges or pan scourers. as they could ruin the glass surface. • Clean the hob, when it is cool, after each use in order to remove any food residues. • Sugar and foods with a high sugar content damage the glass ceramic surface and must be immediately removed.
After-Sales Service Before contacting the After-Sales Service 1. See if you can eliminate the problem on your own by referring to the "Troubleshooting guide". 2. Turn the hob off and on again to check if the problem has been eliminated. If the fault persists after the above checks, contact the nearest After-Sales Service.
Whirlpool Europe S.r.l. Viale G. Borghi, 27 - 21025 Comerio (VA) Phone 0332.759111 - Fax 0332.759268 www.whirlpool.