Instructions for use
These instructions are also available on the website: www.kitchenaid.
Important instructions for safety unless they are supervised by adults. • Do not repair or replace any part of the appliance unless specifically indicated in the manual. Defective parts must be replaced using genuine parts. All other maintenance services must be carried out by a specialized technician. • Children must be supervised to ensure they do not play with the appliance. • When drilling through a wall or the ceiling, pay attention not to damage electric connections and/or pipes.
• For further information on the treatment, recovery and recycling of household appliances, contact your competent local authority, the collection service for household waste or the shop where you purchased the appliance. Scrapping of household appliances • This appliance is manufactured with recyclable or reusable materials. Dispose of it in accordance with local waste disposal regulations. Before disposing of it, make it unusable by cutting off its power supply cable.
Installation This information may be found on the inside of the hood, under the grease filter. Power cable replacement (type H05 VV-F 3 x 0.75 mm²) must be carried out by a qualified electrician. Contact an authorized service centre. If the hood is fitted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place.
Troubleshooting guide • Check the filters are clean; • Check the air vents are not blocked; The light does not work: • Check to see if the lamp needs replacing; • Check to see if the lamp has been fitted properly; The appliance does not work: • Check the domestic power supply and ensure the appliance is connected to the mains properly. • Switch the hood off and then on again to see if the problem has been resolved.
Maintenance WARNING: - use safety gloves. - disconnect the appliance from the mains power supply. GREASE FILTERS The metal grease filter has an unlimited life and should be cleaned once a month by hand or in a dishwasher at low temperature and with a short cycle. Cleaning in a dishwasher may cause discoloring of the grease filter, but its filtering efficiency is unaffected. Pull out the handle to remove the filter. Wash the filter and leave it to dry, proceeding in reverse order to refit.
Material supplied Remove all the components from the packets. Check that all the components are included. • Hood assembled with motor, lamps and grease filters installed. • 1 Pre-assembled truss • 1 Filter connector with extensions • Instructions for assembly and use • 1 electrical cable • 1 cable clamp • 1 Assembly template • 6 screws Ø 6x70 • 6 wall plugs Ø 10x60 • 14 screws Ø 4x7 • 42 screws Ø 3.5x9.
Installation dimensions Adjacent wall units 65 cm (gas or combi cookers) 50 cm (electric cookers) 1200 mm min (120 cm wide model) 900 mm min (90 cm wide model) 700 mm min (70 cm wide model) 600 mm min (60 cm wide model) Adjacent wall units central line hob surface Installation - assembly instructions The instructions below, to be carried out in the order in which they are numbered, refer to the figures (with the same step numbers) given on the last pages of this manual.
8. Hook the truss on the 4 screws (see step 8). WARNING: the side of the truss with electrical connection box corresponds to the side of the control panel with hood assembled. 9. Tighten firmly the 4 screws. 10. Insert and tighten firmly another 2 screws in the remaining free holes for secure fixing. Note - only for Extraction version: connect the upper end of the exhaust duct to the outdoor exhaust device (e.g.: hole on the ceiling). 11.
Maintenance WARNING: - Disconnect the appliance from the power supply Cleaning the perimeter extraction panel Removal: pull the handle (FRONT) firmly downwards. Cleaning: The extraction panel must be cleaned as often as the grease filter, using a rag moistened with neutral liquid detergent. Do not use products containing abrasives. IMPORTANT: Do not use alcohol. Fitting: The panel must be fixed at the front, in the special pins on the hood surface.
Operation Use the fastest speed setting for particularly concentrated steam and fumes. It is advisable to switch the hood on 5 minutes before starting to cook and leave it running for another 15 minutes at the end of cooking.
P 14
X2 15
13a 12 13 13 16
14 14 14 15 17
16 16 17 17 18 18
n Printed in Italy 06/15 400010803598 GB